The DS90CR286A receiver converts the four LVDS data streams back into parallel 28 bits of LVCMOS data. Also available is the DS90CR216A receiver that converts the three LVDS data streams back into parallel 21 bits of LVCMOS data. The outputs of both receivers strobe on the rising edge.
The receiver LVDS clock operates at rates from 20 to 66 MHz. The device phase-locks to the input clock, samples the serial bit streams at the LVDS data lines, and converts them into parallel output data. At an incoming clock rate of 66 MHz, each LVDS input line is running at a bit rate of 462 Mbps, resulting in a maximum throughput of 1.848 Gbps for the DS90CR286A and 1.386 Gbps for the DS90CR216A.
The DS90CR286A and DS90CR216A devices are enhanced over prior generation receivers and provide a wider data valid time on the receiver output. The use of these serial link devices is ideal for solving EMI and cable size problems associated with transmitting data over wide, high speed parallel LVCMOS interfaces. Both devices are offered in TSSOP packages.
| Type | Title | Date | ||
|---|---|---|---|---|
| * | Data sheet | DS90CR286A/-Q1 (or DS90CR216A) 3.3-V Rising Edge Data Strobe LVDS Receiver 28-Bit (or 21-Bit) Channel Link-66 MHz datasheet (Rev. H) | PDF | HTML | 18 Jan 2016 |
| Application note | High-Speed Layout Guidelines for Reducing EMI for LVDS SerDes Designs | 09 Nov 2018 | ||
| Application note | AN-1108 Channel-Link PCB and Interconnect Design-In Guidelines (Rev. A) | 03 Aug 2018 | ||
| Application note | Receiver Skew Margin for Channel Link I and FPD Link I Devices | 13 Jan 2016 | ||
| Design guide | Channel Link I Design Guide | 29 Mar 2007 | ||
| Application note | Multi-Drop Channel-Link Operation | 04 Oct 2004 | ||
| Application note | CHANNEL LINK Moving and Shaping Information In Point-To-Point Applications | 05 Oct 1998 |
For additional terms or required resources, click any title below to view the detail page where available.
The FPD-Link evaluation kit includes a transmitter (Tx) board, a receiver (Rx) board and interfacing cables. This kit shows the chipsets interfacing from test equipment or a graphics controller using low-voltage differential signaling (LVDS) to a receiver board.
The transmitter board accepts (...)
| Package | Pins | CAD symbols, footprints & 3D models |
|---|---|---|
| TSSOP (DGG) | 56 | Ultra Librarian |
Content is provided "as is" by TI and community contributors and does not constitute TI specifications. See terms of use.
If you have questions about quality, packaging or ordering TI products, see TI support.