1 Features

Processor Cores:

Up to Quad 64-bit Arm® Cortex®-A53 microprocessor subsystem at up to 1.4GHz
- Quad-core Cortex-A53 cluster with 512KB L2 shared cache with SECDED ECC
- Each A53 Core has 32KB L1 DCache with SECDED ECC and 32KB L1 ICache with
  Parity protection
Single-core Arm® Cortex®-M4F MCU at up to
400MHz
- 256KB SRAM with SECDED ECC
Dedicated Device/Power Manager

Multimedia:

Memory Subsystem:

Up to 816KB of On-chip RAM
- 64KB of On-chip RAM (OCSRAM) with SECDED ECC , Can be divided into smaller banks in increments of 32KB for as many as 2 separate memory banks
- 256KB of On-chip RAM with SECDED ECC in SMS Subsystem
- 176KB of On-chip RAM with SECDED ECC in SMS Subsystem for TI security firmware
- 256KB of On-chip RAM with SECDED ECC in Cortex-M4F MCU subsystem
- 64KB of On-chip RAM with SECDED ECC in Device/Power Manager Subsystem
DDR Subsystem (DDRSS)
- Integrated 512MB LPDDR4 SDRAM
- Supports speeds up to 1600MT/s
- 16-Bit data bus with inline ECC

Security:

Secure boot supported
- Hardware-enforced Root-of-Trust (RoT)
- Support to switch RoT via backup key
- Support for takeover protection, IP protection, and anti-roll back protection
Trusted Execution Environment (TEE) supported
- Arm TrustZone® based TEE
- Extensive firewall support for isolation
- Secure watchdog/timer/IPC
- Secure storage support
- Replay Protected Memory Block (RPMB) support
Dedicated Security Controller with user programmable HSM core and dedicated security DMA & IPC subsystem for isolated processing
Cryptographic acceleration supported
- Session-aware cryptographic engine with ability to auto-switch key-material based on incoming data stream
  - Supports cryptographic cores
- AES – 128-/192-/256-Bit key sizes
- SHA2 – 224-/256-/384-/512-Bit key sizes
- DRBG with true random number generator
- PKA (Public Key Accelerator) to Assist in RSA/ECC processing for secure boot
Debugging security
- Secure software controlled debug access
- Security aware debugging

PRU Subsystem:

Dual-core Programmable Real-Time Unit Subystem (PRUSS) running up to 333MHz
Intended for driving GPIO for cycle accurate protocols such as additional:
- General Purpose Input/Output (GPIO)
- UARTs
- I²C
- External ADC
16KByte program memory per PRU with
SECDED ECC
8KB data memory per PRU with SECDED ECC
32KB general purpose memory with
SECDED ECC
CRC32/16 HW accelerator
Scratch PAD memory with 3 banks of
30 x 32-bit registers
1 Industrial 64-bit timer with 9 capture and 16 compare events, along with slow and fast compensation
1 interrupt controller (INTC), minimum of 64 input events supported

High-Speed Interfaces:

Integrated Ethernet switch supporting
(total of 2 external ports)
- RMII(10/100) or RGMII (10/100/1000)
- IEEE1588 (Annex D, Annex E, Annex F with 802.1AS PTP)
- Clause 45 MDIO PHY management
- Packet Classifier based on ALE engine with 512 classifiers
- Priority based flow control
- Time sensitive networking (TSN) support
- Four CPU H/W interrupt Pacing
- IP/UDP/TCP checksum offload in hardware
Two USB2.0 Ports
- Port configurable as USB host, USB peripheral, or USB Dual-Role Device (DRD mode)
- Integrated USB VBUS detection

General Connectivity:

9x Universal Asynchronous Receiver-Transmitters (UART)
5x Serial Peripheral Interface (SPI) controllers
6x Inter-Integrated Circuit (I²C) ports
3x Multichannel Audio Serial Ports (McASP)
- Transmit and Receive Clocks up to 50 MHz
- Up to 16/10/6 Serial Data Pins across 3x McASP with Independent TX and RX Clocks
- Supports Time Division Multiplexing (TDM), Inter-IC Sound (I2S), and Similar Formats
- Supports Digital Audio Interface Transmission (SPDIF, IEC60958-1, and AES-3 Formats)
- FIFO Buffers for Transmit and Receive
  (256 Bytes)
- Support for audio reference output clock
3x enhanced PWM modules (ePWM)
3x enhanced Quadrature Encoder Pulse modules (eQEP)
3x enhanced Capture modules (eCAP)
General-Purpose I/O (GPIO), All LVCMOS I/O can be configured as GPIO
3x Controller Area Network (CAN) modules with CAN-FD support
- Conforms w/ CAN Protocol 2.0 A, B and ISO 11898-1
- Full CAN FD support (up to 64 data bytes)
- Parity/ECC check for Message RAM
- Speed up to 8Mbps

Media and Data Storage:

3x Multi-Media Card/Secure Digital®
(MMC/SD®/SDIO) interface
- 1x 8-bit eMMC interface up to HS200 speed
- 2x 4-bit SD/SDIO interface up to UHS-I
- Compliant with eMMC 5.1, SD 3.0 and
  SDIO Version 3.0
1× General-Purpose Memory Controller (GPMC) up to 133 MHz
- Flexible 8- and 16-Bit Asynchronous Memory Interface With up to four Chip (22-bit address) Selects (NAND, NOR, Muxed-NOR, and SRAM)
- Uses BCH Code to Support 4-, 8-, or 16-Bit ECC
- Uses Hamming Code to Support 1-Bit ECC
- Error Locator Module (ELM)
  - Used With the GPMC to Locate Addresses of Data Errors From Syndrome Polynomials Generated Using a BCH Algorithm
  - Supports 4-, 8-, and 16-Bit Per 512-Byte Block Error Location Based on BCH Algorithms
OSPI/QSPI with DDR / SDR support
- Support for Serial NAND and Serial NOR flash devices
- 4GBytes memory address support
- XIP mode with optional on-the-fly encryption

Power Management:

Optimal Power Management Solution:

Recommended TPS65219 Power Management ICs (PMIC)
- Companion PMIC specially designed to meet device power supply requirements
- Flexible mapping and factory programmed configurations to support different use cases

Boot Options:

Technology / Package: