SBAS996 Data sheet | TI.com

SBAS996B May 2020 – April 2021 AMC3306M25

PRODUCTION DATA

Package Options

Mechanical Data (Package|Pins)

DWE|16
- MPSS091

Thermal pad, mechanical data (Package|Pins)

Orderable Information

6.13 Typical Characteristics

at VDD = 3.3 V, INP = –250 mV to +250 mV, INN = HGND, f_CLKIN = 20 MHz, and sinc³ filter with OSR = 256, 16-bit resolution (unless otherwise noted)

Figure 6-6 Input Bias Current vs Common-Mode Input Voltage

Figure 6-8 Input Bias Current vs Temperature

Figure 6-10 Offset Error vs Supply Voltage

Figure 6-12 Gain Error vs Input Clock Frequency

Figure 6-14 Gain Error vs Temperature

Figure 6-16 Integral Nonlinearity vs
Input Clock Frequency

Figure 6-18 Integral Nonlinearity vs Temperature

Figure 6-20 Signal-to-Noise Ratio and Signal-to-Noise + Distortion vs Input Signal Frequency

Figure 6-22 Signal-to-Noise Ratio and Signal-to-Noise + Distortion vs Supply Voltage

Figure 6-24 Total Harmonic Distortion vs
Input Signal Amplitude

Figure 6-26 Total Harmonic Distortion vs
Input Clock Frequency

Figure 6-28 Total Harmonic Distortion vs Temperature

Figure 6-30 Spurious-Free Dynamic Range vs Input Signal Frequency

Figure 6-32 Spurious-Free Dynamic Range vs Supply Voltage

Figure 6-34 Output Frequency Spectrum With
1-kHz Input Signal

Figure 6-36 Common-Mode Rejection Ratio vs
Input Signal Frequency

Figure 6-38 Supply Current vs Supply Voltage

Figure 6-40 Supply Current vs Temperature

Figure 6-42 I_H Derating vs Temperature

Figure 6-7 Input Bias Current vs Supply Voltage

Figure 6-9 Offset Error Histogram

Figure 6-11 Offset Error vs Temperature

Figure 6-13 Gain Error vs Supply Voltage

Figure 6-15 Integral Nonlinearity vs Input Voltage

Figure 6-17 Integral Nonlinearity vs
Supply Voltage

Figure 6-19 Signal-to-Noise Ratio and Signal-to-Noise + Distortion vs Input Signal Amplitude

Figure 6-21 Signal-to-Noise Ratio and Signal-to-Noise + Distortion vs Input Clock Frequency

Figure 6-23 Signal-to-Noise Ratio and Signal-to-Noise + Distortion vs Temperature

Figure 6-25 Total Harmonic Distortion vs
Input Signal Frequency

Figure 6-27 Total Harmonic Distortion vs
Supply Voltage

Figure 6-29 Spurious-Free Dynamic Range vs Input Signal Amplitude

Figure 6-31 Spurious-Free Dynamic Range vs Input Clock Frequency

Figure 6-33 Spurious-Free Dynamic Range vs Temperature

Figure 6-35 Output Frequency Spectrum With
10-kHz Input Signal

Figure 6-37 Power-Supply Rejection Ratio vs Ripple Frequency

Figure 6-39 Supply Current vs
Input Clock Frequency

Figure 6-41 High-Side LDO Output Voltage vs Supply Voltage