SLIS146G June   2012  – September 2017 BQ24392

PRODUCTION DATA.  

  1. Features
  2. Applications
  3. Description
  4. Revision History
  5. Pin Configuration and Functions
  6. Specifications
    1. 6.1 Absolute Maximum Ratings
    2. 6.2 ESD Ratings
    3. 6.3 Recommended Operating Conditions
    4. 6.4 Thermal Information
    5. 6.5 Electrical Characteristics
    6. 6.6 Typical Characteristics
  7. Detailed Description
    1. 7.1 Overview
    2. 7.2 Functional Block Diagram
    3. 7.3 Feature Description
      1. 7.3.1 Charger Detection
    4. 7.4 Device Functional Modes
  8. Application and Implementation
    1. 8.1 Application Information
      1. 8.1.1 Using the BQ24392 GPIOs
        1. 8.1.1.1 CHG_AL and CHG_DET
        2. 8.1.1.2 SW_OPEN
        3. 8.1.1.3 GOOD_BAT
        4. 8.1.1.4 Slow Plug-in Event
    2. 8.2 Typical Application
      1. 8.2.1 Design Requirements
      2. 8.2.2 Detailed Design Procedure
      3. 8.2.3 Application Curves
  9. Power Supply Recommendations
  10. 10Layout
    1. 10.1 Layout Guidelines
    2. 10.2 Layout Example
  11. 11Device and Documentation Support
    1. 11.1 Receiving Notification of Documentation Updates
    2. 11.2 Community Resources
    3. 11.3 Trademarks
    4. 11.4 Electrostatic Discharge Caution
  12. 12Mechanical, Packaging, and Orderable Information

Package Options

Mechanical Data (Package|Pins)
Thermal pad, mechanical data (Package|Pins)
Orderable Information

Pin Configuration and Functions

RSE Package
10-Pin (UQFN)
(Top View)
BQ24392 pinout_lis146.gif

Pin Functions

PIN I/O DESCRIPTION
NO. NAME
1 SW_OPEN O USB switch status indicator
Open-drain output. 10kΩ external pull-up resistor required
SW_OPEN = LOW indicates when switch is connected
SW_OPEN = HIGH-Z indicates when then switch is not connected
2 DM_HOST I/O D– signal to transceiver
3 DP_HOST I/O D+ signal to transceiver
4 CHG_AL_N O Charging status indicator
Open-drain output. 10kΩ external pull-up resistor required
CHG_AL_N = LOW indicates when charging is allowed
CHG_AL_N = HIGH-Z indicates when charging is not allowed
5 GOOD_BAT I Battery status indication from system
GOOD_BAT = LOW indicates a dead battery
GOOD_BAT = HIGH indicates a good battery
6 GND - Ground
7 DP_CON I/O D+ signal from USB connector
8 DM_CON I/O D– signal from USB connector
9 VBUS I Supply pin from USB connector
10 CHG_DET O Charger detection indicator
Push-Pull output to system
CHG_DET = LOW indicates when a charger is not detected
CHG_DET = HIGH indicates when a charger detected