SWAS031D June   2013  – February 2015 CC3100

PRODUCTION DATA.  

  1. 1Device Overview
    1. 1.1 Features
    2. 1.2 Applications
    3. 1.3 Description
    4. 1.4 Functional Block Diagram
  2. 2Revision History
  3. 3Terminal Configuration and Functions
    1. 3.1 Pin Attributes
  4. 4Specifications
    1. 4.1  Absolute Maximum Ratings
    2. 4.2  Handling Ratings
    3. 4.3  Power-On Hours
    4. 4.4  Recommended Operating Conditions
    5. 4.5  Brown-Out and Black-Out
    6. 4.6  Electrical Characteristics (3.3 V, 25°C)
    7. 4.7  WLAN Receiver Characteristics
    8. 4.8  WLAN Transmitter Characteristics
    9. 4.9  Current Consumption
    10. 4.10 Thermal Characteristics for RGC Package
    11. 4.11 Timing and Switching Characteristics
      1. 4.11.1 Power Supply Sequencing
      2. 4.11.2 Reset Timing
        1. 4.11.2.1 nRESET (32K XTAL)
        2. 4.11.2.2 nRESET (External 32K)
        3. 4.11.2.3 Wakeup from Hibernate
      3. 4.11.3 Clock Specifications
        1. 4.11.3.1 Slow Clock Using Internal Oscillator
        2. 4.11.3.2 Slow Clock Using an External Clock
        3. 4.11.3.3 Fast Clock (Fref) Using an External Crystal
        4. 4.11.3.4 Fast Clock (Fref) Using an External Oscillator
        5. 4.11.3.5 Input Clocks/Oscillators
        6. 4.11.3.6 WLAN Filter Requirements
      4. 4.11.4 Interfaces
        1. 4.11.4.1 Host SPI Interface Timing
        2. 4.11.4.2 Flash SPI Interface Timing
    12. 4.12 External Interfaces
      1. 4.12.1 SPI Flash Interface
      2. 4.12.2 SPI Host Interface
    13. 4.13 Host UART
      1. 4.13.1 5-Wire UART Topology
      2. 4.13.2 4-Wire UART Topology
      3. 4.13.3 3-Wire UART Topology
  5. 5Detailed Description
    1. 5.1 Overview
      1. 5.1.1 Device Features
        1. 5.1.1.1 WLAN
        2. 5.1.1.2 Network Stack
        3. 5.1.1.3 Host Interface and Driver
        4. 5.1.1.4 System
    2. 5.2 Functional Block Diagram
    3. 5.3 Wi-Fi Network Processor Subsystem
    4. 5.4 Power-Management Subsystem
      1. 5.4.1 VBAT Wide-Voltage Connection
      2. 5.4.2 Preregulated 1.85 V
    5. 5.5 Low-Power Operating Modes
      1. 5.5.1 Low-Power Deep Sleep
      2. 5.5.2 Hibernate
    6. 5.6 Memory
      1. 5.6.1 External Memory Requirements
  6. 6Applications and Implementation
    1. 6.1 Application Information
      1. 6.1.1 Typical Application - CC3100 Wide-Voltage Mode
      2. 6.1.2 Typical Application - CC3100 Preregulated 1.85-V Mode
  7. 7Device and Documentation Support
    1. 7.1 Device Support
      1. 7.1.1 Development Support
        1. 7.1.1.1 Radio Tool
        2. 7.1.1.2 Uniflash Flash Programmer
      2. 7.1.2 Device Nomenclature
    2. 7.2 Documentation Support
    3. 7.3 Community Resources
    4. 7.4 Trademarks
    5. 7.5 Electrostatic Discharge Caution
    6. 7.6 Glossary
  8. 8Mechanical Packaging and Orderable Information

Package Options

Mechanical Data (Package|Pins)
Thermal pad, mechanical data (Package|Pins)
Orderable Information

2 Revision History

Changes from C Revision (August 2014) to D Revision

  • Added Wi-Fi CERTIFIEDGo
  • Changed TCP value from 12 Mbps in Section 1.1, FeaturesGo
  • Changed part number in Device Information table from CC3100Go
  • Changed pin 19 from NC and pin 18 from reserved in Figure 3-1Go
  • Changed pin 19 from NC in Table 3-1Go
  • Added to pin 2 (nHIB) description in Table 3-1Go
  • Changed pins 8 and 14 to active low Go
  • Changed pin 15 to active high Go
  • Added note in Section 4.4, Recommended Operating Conditions, on avoiding the PA auto-protect featureGo
  • Added Section 4.5, Brown-Out and Black-OutGo
  • Added Table 4-1Go
  • Added VIL (nRESET pin) and corresponding note in Section 4.6, Electrical Characteristics (3.3 V, 25°C)Go
  • Added note on RX current measurement in Section 4.9Current Consumption.Go
  • Changed Thib_min description from "minimum pulse width of nHIB = 0" in Table 4-4Go
  • Added footnote in Table 4-4 to ensure that the nHIB pulse width is kept above the minimum requirement. Go
  • Changed frequency accuracy from ±20 ppm in Table 4-5Go
  • Added Section 4.11.3.6, WLAN Filter RequirementsGo
  • Added note on asserting nCS (active low signal) in Table 4-10Go
  • Changed HOST_SPI_CS to HOST_SPI_nCS in Table 4-13Go
  • Changed H_IRQ to HOST_INTR(IRQ) in Figure 4-17Go
  • Changed TCP of item 17 from 12 Mbps in Table 5-1Go
  • Changed part number of item 13 from XCC3100RTD in Table 6-1Go
  • Added note following Table 6-1Go
  • Changed part number of item 13 from XCC3100RTD in Table 6-2Go
  • Added note following Table 6-2Go