SLPS393A October   2013  – January 2015 CSD17571Q2

PRODUCTION DATA.  

  1. 1Features
  2. 2Applications
  3. 3Description
  4. 4Revision History
  5. 5 Specifications
    1. 5.1 Electrical Characteristics
    2. 5.2 Thermal Information
    3. 5.3 Typical MOSFET Characteristics
  6. 6Device and Documentation Support
    1. 6.1 Trademarks
    2. 6.2 Electrostatic Discharge Caution
    3. 6.3 Glossary
  7. 7Mechanical, Packaging, and Orderable Information
    1. 7.1 Q2 Package Dimensions
      1. 7.1.1 Recommended PCB Pattern
      2. 7.1.2 Recommended Stencil Pattern
    2. 7.2 Q2 Tape and Reel Information

Package Options

Refer to the PDF data sheet for device specific package drawings

Mechanical Data (Package|Pins)
  • DQK|6
Thermal pad, mechanical data (Package|Pins)
Orderable Information

7 Mechanical, Packaging, and Orderable Information

The following pages include mechanical, packaging, and orderable information. This information is the most current data available for the designated devices. This data is subject to change without notice and revision of this document. For browser-based versions of this data sheet, refer to the left-hand navigation.

7.1 Q2 Package Dimensions

M0165-01_LPS235.gif
DIM MILLIMETERS INCHES
MIN NOM MAX MIN NOM MAX
A 0.700 0.750 0.800 0.028 0.030 0.032
A1 0.000 0.050 0.000 0.002
b 0.250 0.300 0.350 0.010 0.012 0.014
C 0.203 TYP 0.008 TYP
D 2.000 TYP 0.080 TYP
D1 0.900 0.950 1.000 0.036 0.038 0.040
D2 0.300 TYP 0.012 TYP
E 2.000 TYP 0.080 TYP
E1 0.900 1.000 1.100 0.036 0.040 0.044
E2 0.280 TYP 0.0112 TYP
E3 0.470 TYP 0.0188 TYP
e 0.650 BSC 0.026 TYP
K 0.280 TYP 0.0112 TYP
K1 0.350 TYP 0.014 TYP
K2 0.200 TYP 0.008 TYP
K3 0.200 TYP 0.008 TYP
K4 0.470 TYP 0.0188 TYP
L 0.200 0.25 0.300 0.008 0.010 0.012

7.1.1 Recommended PCB Pattern

Recommended_PCB_Pattern.png

For recommended circuit layout for PCB designs, see application note SLPA005 – Reducing Ringing Through PCB Layout Techniques.

7.1.2 Recommended Stencil Pattern

Recommended_Stencil_Pattern.png

NOTE:

All dimensions are in mm, unless otherwise specified.

7.2 Q2 Tape and Reel Information

M0168-01_LPS235.gif

NOTES:

1. Measured from centerline of sprocket hole to centerline of pocket
2. Cumulative tolerance of 10 sprocket holes is ±0.20
3. Other material available
4. Typical SR of form tape Max 109 OHM/SQ
5. All dimensions are in mm, unless otherwise specified.