4 Revision History
Changes from Revision B (December 2015) to Revision C (December 2021)
- Updated the numbering format for tables, figures,
and cross-references throughout the
documentGo
- Changed Applications section to link to official TI.com End
Equipment pagesGo
- Remove mention of input offset laser trimming (do not include in Rev
history)Go
- Added dual supply specification to Absolute Maximum Ratings
Go
- Deleted redundant operating temperature and input common mode voltage specifications in Recommended Operating Conditions
Go
- Added dual supply and specified temperature specifications in Recommended Operating Conditions
Go
- Added proper signs for PSRR and input bias current specifications in Electrical Characteristics
Go
- Deleted VO = 0 V test condition of common-mode voltage specification in Electrical Characteristics
Go
- Changed common-mode voltage specification from ±11.25 V minimum, to –11.25 V minimum and 11.25 V maximum, in Electrical Characteristics
Go
- Changed minimum CMRR specification for INA126U/E, INA2126E from 83 dB to 80 dB in Electrical Characteristics
Go
- Added typical input bias current specification of ±10 nA for INA126PA/UA/EA and INA2126PA/UA/EA in Electrical Characteristics
Go
- Changed current noise specifications in Electrical Characteristics from 60 fA/√Hz to 160 fA/√Hz for f = 1 kHz, and from 2 pApp to 7.3 pApp for f = 0.1 Hz to 10 HzGo
- Changed test condition for short-circuit current specification in Electrical Characteristics from "Short circuit to ground" to "Continuous to VS / 2" for clarityGo
- Changed short-circuit current specification in Electrical Characteristics from +10/-5 mA to ±5 mAGo
- Deleted redundant voltage range, operating temperature range, and specification temperature range specifications from Electrical Characteristics
Go
- Changed Figures 6-7,
6-10, 6-13, 6-14, 6-15, 6-16, 6-17 Go
- Added Figure 6-11Go
- Changed figureGo
- Remove mention of input offset laser trimming (do not include in Rev
history)Go
Changes from Revision A (August 2005) to Revision B (December 2015)
- Added ESD Ratings table, Feature Description section, Device Functional Modes, Application and Implementation section, Power Supply Recommendations section, Layout section, Device and Documentation Support section, and Mechanical, Packaging, and Orderable Information sectionGo