SLLSEM3 Data sheet

SLLSEM3H November 2014 – May 2024 ISO7841

PRODUCTION DATA

Package Options

Refer to the PDF data sheet for device specific package drawings

Mechanical Data (Package|Pins)

DWW|16
DW|16

Thermal pad, mechanical data (Package|Pins)

Orderable Information

5.17 Switching Characteristics—2.5V Supply

V_CC1 = V_CC2 = 2.5V ±10% (over recommended operating conditions unless otherwise noted)

PARAMETER		TEST CONDITIONS	MIN	TYP	MAX	UNIT
t_PLH, t_PHL	Propagation delay time	See Figure 6-1	7.5	11.7	17.5	ns
PWD	Pulse width distortion⁽¹⁾ \|t_PHL – t_PLH\|	See Figure 6-1		0.66	4.2	ns
t_sk(o)	Channel-to-channel output skew time⁽²⁾	Same-direction Channels			2.2	ns
t_sk(pp)	Part-to-part skew time⁽³⁾				4.5	ns
t_r	Output signal rise time	See Figure 6-1		1	3.5	ns
t_f	Output signal fall time	See Figure 6-1		1.2	3.5	ns
t_PHZ	Disable propagation delay, high-to-high impedance output	See Figure 6-2		22	45	ns
t_PLZ	Disable propagation delay, low-to-high impedance output			22	45	ns
t_PZH	Enable propagation delay, high impedance-to-high output for ISO7841			18	45	ns
t_PZH	Enable propagation delay, high impedance-to-high output for ISO7841F			2	2.5	μs
t_PZL	Enable propagation delay, high impedance-to-low output for ISO7841			2	2.5	μs
t_PZL	Enable propagation delay, high impedance-to-low output for ISO7841F			18	45	ns
t_fs	Default output delay time from input power loss	Measured from the time V_CC goes below 1.7V. See Figure 6-3		0.2	9	μs
t_ie	Time interval error	2¹⁶ – 1 PRBS data at 100Mbps		0.91		ns

(1) Also known as pulse skew.

(2) t_sk(o) is the skew between outputs of a single device with all driving inputs connected together and the outputs switching in the same direction while driving identical loads.

(3) t_sk(pp) is the magnitude of the difference in propagation delay times between any terminals of different devices switching in the same direction while operating at identical supply voltages, temperature, input signals and loads.