SBOS567 Data sheet

SBOS567A June 2011 – February 2024 OPA564-Q1

PRODUCTION DATA

Package Options

Refer to the PDF data sheet for device specific package drawings

Mechanical Data (Package|Pins)

DWP|20

Thermal pad, mechanical data (Package|Pins)

DWP|20
- PPTD006E

Orderable Information

6.6 Typical Characteristics

at T_CASE = 25°C, V_S = ±12V, R_LOAD = 20kΩ to GND, R_SET = 7.5kΩ, and E/S pin enabled (unless otherwise noted)

Figure 6-1 Quiescent Current vs Supply Voltage

No load

Figure 6-3 Large−Signal Step Response

Figure 6-5 Small−Signal Step Response

Figure 6-7 I_Q vs Temperature

Figure 6-9 A_OL, PSRR, and CMRR vs Temperature

Figure 6-11 I_Q, Shutdown vs Temperature

Figure 6-13 Gain and Phase vs Frequency

Figure 6-15 Output Voltage Swing vs Frequency

Figure 6-17 Total Harmonic Distortion + Noise vs Amplitude

Figure 6-19 Total Harmonic Distortion + Noise vs Amplitude

Figure 6-21 Total Harmonic Distortion + Noise vs Frequency

Figure 6-23 Input Voltage Spectral Noise and Current Noise vs Frequency

No load

Figure 6-25 Closed-Loop Output Impedance

R_LOAD = 100Ω

Figure 6-27 Enable Response

Figure 6-29 Enable Time (Inverting Configuration)

Figure 6-31 Output Current Limit vs R_SET (Sourcing Current)

Figure 6-33 Quiescent Current Increase vs R_SET

Figure 6-2 Output Voltage Swing vs Output Current

Figure 6-4 Large−Signal Step Response

Figure 6-6 Small−Signal Overshoot vs Load Capacitance

Figure 6-8 Offset Voltage vs Temperature

Figure 6-10 I_B vs Temperature

Figure 6-12 I_DIG vs Temperature

Figure 6-14 Common-Mode Rejection Ratio and Power-Supply Rejection Ratio vs Frequency

Figure 6-16 Output Voltage Swing vs Frequency

Figure 6-18 Total Harmonic Distortion + Noise vs Amplitude

Figure 6-20 Total Harmonic Distortion + Noise vs Frequency

Figure 6-22 Total Harmonic Distortion + Noise vs Frequency

No load

Figure 6-24 Open-Loop Output Impedance

Figure 6-26 Input Bias Current vs Common-Mode Voltage

Figure 6-28 Shutdown Time (Inverting Configuration)

Figure 6-30 Current Limit Percent Error vs R_SET

Figure 6-32 Output Current Limit vs R_SET (Sinking Current)

Figure 6-34 Offset Voltage Production Distribution