7.7.1 Typical Characteristics: VS = 2.7 V
Test conditions unless otherwise noted: VS+ = 2.7 V, VS– = 0 V, CM = open, VOUT = 2 Vpp, RF = 2 kΩ, RL = 2 kΩ Differential, G = 1 V/V, Single-Ended Input, Differential Output, Input and Output Referenced to mid-supply, TA ≈ 25°C, unless otherwise noted.
Figure 1. Small-Signal Frequency Response
Figure 3. Large- and Small-Signal Pulse Response
Figure 5. Differential Slew Rate vs VOUT Step
Figure 7. 10-kHz FFT On Audio Analyzer
Figure 9. Harmonic Distortion vs Output Voltage at 1 MHz
Figure 11. Harmonic Distortion vs Load at 1 MHz
Figure 13. Two-Tone, 2nd and 3rd Order Intermodulation
Distortion vs Frequency
Figure 15. Single-Ended Output Saturation Voltage vs Load Current
Figure 17. Frequency Response vs CLOAD
Figure 19. Rejection Ratio vs Frequency
Figure 21. Turnoff Time
Figure 23. Main Amplifier Differential Open-Loop Gain and Phase vs Frequency
Figure 25. VOCM Small-Signal Frequency Response
Figure 27. VOCM Input Impedance vs Frequency
Figure 29. Input Offset Current Temp Drift Histogram
Figure 31. Input Offset Voltage Histogram
Figure 33. Input Offset Voltage vs Temperature
Figure 2. Large-Signal Frequency Response
Figure 4. Single-Ended Slew Rate vs VOUT Step
Figure 6. Overdrive Recovery
Figure 8. Harmonic Distortion vs Frequency
Figure 10. Harmonic Distortion vs Gain at 1 MHz
Figure 12. Harmonic Distortion vs VOCM at 1 MHz
Figure 14. Single-Ended Output Voltage Swing vs Load Resistance
Figure 16. Main Amplifier Differential Output Impedance vs Frequency
Figure 18. RO vs CLOAD
Figure 20. Turnon Time
Figure 22. Input-Referred Voltage Noise and Current Noise Spectral Density
Figure 24. Output Balance Error vs Frequency
Figure 26. VOCM Large- and Small Signal Pulse Response
Figure 28. Input Offset Current Histogram
Figure 30. Input Offset Current vs Temperature
Figure 32. Input Offset Voltage Temp Drift Histogram