2 Revision History
Changes from C Revision (August 2014) to D Revision
-
Added Wi-Fi CERTIFIEDGo
-
Changed TCP value from 12 Mbps in Section 1.1, FeaturesGo
-
Changed part number in Device Information table from CC3100Go
-
Changed pin 19 from NC and pin 18 from reserved in Figure 3-1Go
-
Changed pin 19 from NC in Table 3-1Go
-
Added to pin 2 (nHIB) description in Table 3-1Go
-
Changed pins 8 and 14 to active low Go
-
Changed pin 15 to active high Go
-
Added note in Section 4.4, Recommended Operating Conditions, on avoiding the PA auto-protect featureGo
-
Added Section 4.5, Brown-Out and Black-OutGo
-
Added Table 4-1Go
-
Added VIL (nRESET pin) and corresponding note in Section 4.6, Electrical Characteristics (3.3 V, 25°C)Go
-
Added note on RX current measurement in Section 4.9Current Consumption.Go
-
Changed Thib_min description from "minimum pulse width of nHIB = 0" in Table 4-4Go
-
Added footnote in Table 4-4 to ensure that the nHIB pulse width is kept above the minimum requirement. Go
-
Changed frequency accuracy from ±20 ppm in Table 4-5Go
-
Added Section 4.11.3.6, WLAN Filter RequirementsGo
-
Added note on asserting nCS (active low signal) in Table 4-10Go
-
Changed HOST_SPI_CS to HOST_SPI_nCS in Table 4-13Go
-
Changed H_IRQ to HOST_INTR(IRQ) in Figure 4-17Go
-
Changed TCP of item 17 from 12 Mbps in Table 5-1Go
-
Changed part number of item 13 from XCC3100RTD in Table 6-1Go
-
Added note following Table 6-1Go
-
Changed part number of item 13 from XCC3100RTD in Table 6-2Go
-
Added note following Table 6-2Go