SLVSHA4 June   2024 DRV8421

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Device Comparison
  6. 5 Pin Configuration and Functions
  7. 6 Specifications
    1. 6.1 Absolute Maximum Ratings
    2. 6.2 ESD Ratings Comm
    3. 6.3 Recommended Operating Conditions
    4. 6.4 Thermal Information
    5. 6.5 Electrical Characteristics
    6. 6.6 Timing Requirements
    7. 6.7 Typical Characteristics
  8. 7 Detailed Description
    1. 7.1 Overview
    2. 7.2 Functional Block Diagrams
    3. 7.3 Feature Description
      1. 7.3.1 PWM Motor Drivers
      2. 7.3.2 Truth Tables
      3. 7.3.3 Parallel Operation
      4. 7.3.4 Protection Circuits
        1. 7.3.4.1 OCP
        2. 7.3.4.2 TSD
        3. 7.3.4.3 UVLO
    4. 7.4 Device Functional Modes
  9. 8 Application and Implementation
    1. 8.1 Application Information
    2. 8.2 Typical Application
      1. 8.2.1 Design Requirements
      2. 8.2.2 Application Curves
    3. 8.3 Power Supply Recommendations
      1. 8.3.1 Bulk Capacitance Sizing
    4. 8.4 Layout
      1. 8.4.1 Layout Guidelines
      2. 8.4.2 Layout Example
  10. 9 Device and Documentation Support
    1. 9.1 Community Resources
    2. 9.2 Trademarks
  11. 10Revision History
  12. 11Mechanical, Packaging, and Orderable Information

パッケージ・オプション

メカニカル・データ（パッケージ｜ピン）
サーマルパッド・メカニカル・データ
発注情報

7.4 Device Functional Modes

The DRV8421A is active until power is switched off. The DRV8421B is active until power is switched off or unless the EN pin is brought logic low which forces the device into sleep mode. In sleep mode, the H-bridge FETs are disabled Hi-Z. Note that tSLEEP must elapse EN pin before the device goes to sleep mode. The DRV8421B is brought out of sleep mode automatically if EN pin is brought logic high. Note that tWAKE must elapse before the output change state after wake-up.

When VVM falls below the VM UVLO threshold (VUVLO), the output driver and internal logic are reset.

Table 7-6 Functional Modes
MODECONDITIONH-BRIDGEVINT
Operating4 V < VVM < 18 V
nSLEEP pin = 1		OperatingOperating
Sleep4 V < VVM < 18 V
EN pin = 0		DisabledDisabled
FaultAny fault condition metDisabledDepends on fault