Input capacitors, output capacitors, and MOSFETs are the constituent components of the power stage of a buck regulator and are typically placed on the top side of the PCB (solder side). The benefits of convective heat transfer are maximized because of leveraging any system-level airflow. In a two-sided PCB layout, small-signal components are typically placed on the bottom side (component side). Insert at least one inner plane, connected to ground, to shield and isolate the small-signal traces from noisy power traces and lines.
The DC/DC regulator has several high-current
loops. Minimize the area of these loops to
suppress generated switching noise and optimize
switching performance.
Loop 1: The most important loop area to minimize
is the path from the input capacitor or capacitors
through the high- and low-side MOSFETs, and back
to the capacitor or capacitors through the ground
connection. Connect the input capacitor or
capacitors negative terminal close to the source
of the low-side MOSFET (at ground). Similarly,
connect the input capacitor or capacitors positive
terminal close to the drain of the high-side
MOSFET (at VIN). Refer to "loop 1" in Figure 8-25.
Another loop, not as critical as loop 1, is the
path from the low-side MOSFET through the inductor
and output capacitor or capacitors, and back to
source of the low-side MOSFET through ground.
Connect the source of the low-side MOSFET and
negative terminal of the output capacitor or
capacitors at ground as close as possible.
The PCB trace defined as SW node, which connects to the source of the high-side (control) MOSFET, the drain of the low-side (synchronous) MOSFET and the high-voltage side of the inductor, must be short and wide. However, the SW connection is a source of injected EMI and thus must not be too large.
Follow any layout considerations of the MOSFETs as recommended by the MOSFET manufacturer, including pad geometry and solder paste stencil design.
The SW pin connects to the switch node of the
power conversion stage and acts as the return path
for the high-side gate driver. The parasitic
inductance inherent to loop 1 in Figure 8-25 and the output capacitance
(COSS) of both power MOSFETs form a
resonant circuit that induces high frequency
(greater than 50MHz) ringing at the SW node. The
voltage peak of this ringing, if not controlled,
can be significantly higher than the input
voltage. Make sure that the peak ringing amplitude
does not exceed the absolute maximum rating limit
for the SW pin. In many cases, a series resistor
and capacitor snubber network connected from the
SW node to GND damps the ringing and decreases the
peak amplitude. Provide provisions for snubber
network components in the PCB layout. If testing
reveals that the ringing amplitude at the SW pin
is excessive, then include snubber components as
needed.