SLASEV3 Data sheet

SLASEV3A March 2020 – December 2020 MSP430FR6005 , MSP430FR6007

PRODUCTION DATA

パッケージ・オプション

メカニカル・データ（パッケージ｜ピン）

PZ|100
- MTQF013A

サーマルパッド・メカニカル・データ

PZ|100
- QFND428

発注情報

jajsit2_oa

8.13.4.2 Typical Wake-up Charges

over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)⁽¹⁾

PARAMETER		TEST CONDITIONS	TYP	UNIT
Q_{WAKE-UP FRAM}	Charge used for activating the FRAM in AM or during wakeup from LPM0 if previously disabled by the FRAM controller.		16.5	nAs
Q_{WAKE-UP LPM0}	Charge used to wake up from LPM0 to active mode (with FRAM active)		3.8	nAs
Q_{WAKE-UP LPM1}	Charge used to wake up from LPM1 to active mode (with FRAM active)		21	nAs
Q_{WAKE-UP LPM2}	Charge used to wake up from LPM2 to active mode (with FRAM active)		22	nAs
Q_{WAKE-UP LPM3}	Charge used to wake up from LPM3 to active mode (with FRAM active)		28	nAs
Q_{WAKE-UP LPM4}	Charge used to wake up from LPM4 to active mode (with FRAM active)		28	nAs
Q_{WAKE-UP LPM3.5}	Charge used to wake up from LPM3.5 to active mode⁽²⁾		170	nAs
Q_{WAKE-UP LPM4.5}	Charge used to wake up from LPM4.5 to active mode⁽²⁾	SVSHE = 1	173	nAs
Q_{WAKE-UP LPM4.5}	Charge used to wake up from LPM4.5 to active mode⁽²⁾	SVSHE = 0	171	nAs
Q_{WAKE-UP-RESET}	Charge used for reset from RST or BOR event to active mode⁽²⁾		148	nAs

(1) Charge used during the wake-up time from a given low-power mode to active mode. This does not include the energy required in active mode (for example, for an interrupt service routine).

(2) Charge required until start of user code. This does not include the energy required to reconfigure the device.