JAJSRO9 データシート

JAJSRO9C January 1989 – October 2023 SN75ALS197

PRODUCTION DATA

デバイスごとのパッケージ図は、PDF版データシートをご参照ください。

5.5 Electrical Characteristics

over recommended range of common-mode input voltage, supply voltage, and operating free-air temperature (unless otherwise noted)

PARAMETER		TEST CONDITIONS		MIN	TYP^⁽¹⁾	MAX	UNIT
V_IT+	Positive-going input threshold voltage					300	mV
V_IT−	Negative-going input threshold voltage			−300^⁽¹⁾			mV
V_hys	Hysteresis voltage (V_IT+ − V_IT−)	See Figure 5-1			120		mV
V_IK	Enable-input clamp voltage	I_I = −18 mA				−1.5	V
V_OH	High-level output voltage	V_ID = 300 mV,	I_OH = − 400 μA	2.7	1.6		V
V_OL	Low-level output voltage	V_ID = −300 mV	I_OL = 8 mA			0.45	V
V_OL	Low-level output voltage	V_ID = −300 mV	I_OL = 16 mA			0.5	V
I_OZ	High-impedance-state output current	V_CC = 5.25 V	V_O = 2.4 V			20	μA
I_OZ	High-impedance-state output current	V_CC = 5.25 V	V_OH = 0.4 V			−20	μA
I_I	Line input current	Other input at 0 V, See ^{Note 3}	V_I = 15 V		0.7	1.2	μA
I_I	Line input current	Other input at 0 V, See ^{Note 3}	V_I = −15 V		−1.0	−1.7	μA
I_H	High-level enable-input current		V_IH = 2.7 V			20	μA
I_H	High-level enable-input current		V_IH = 5.25 V			100	μA
I_IL	Low-level enable-input current	V_IL = 0.4 V				−100	μA
	Input resistance			12	18		kΩ
I_OS	Short-circuit output current^⁽²⁾	V_ID = 3 V,	V_O = 0	−15	−78	−130	mA
I_CC	Supply current	Outputs disabled			22	35	mA

(1) The algebraic convention, in which the less positive limit is designated minimum, is used in this data sheet for threshold voltage levels only.

(2) Not more than one output should be shorted at a time, and the duration of the short circuit should not exceed one second.

(3) Refer to ANSI Standard EIA/TIA-422-B and EIA/TIA-423-B for exact conditions.