This section describes the necessary steps to configure the TAC5112 for this specific application. The following steps provide a sequence of items that must be executed in the time between powering the device up and reading data from the device or transitioning from one mode to another mode of operation.

1. Apply power to the device:
   1. Power up the IOVDD and AVDD power supplies
   2. Wait for at least 2ms to allow the device to initialize the internal registers.
   3. The device now goes into sleep mode (low-power mode < 10µA)
2. Transition from sleep mode to active mode whenever required for the operation:
   1. Wake up the device by writing to P0_R2 to disable sleep mode
   2. Wait for at least 2ms to allow the device to complete the internal wake-up sequence
   3. Override the default configuration registers or programmable coefficients value as required (this step is optional)
   4. Enable all desired input channels by writing to P0_R118
   5. Enable all desired audio serial interface input/output channels by writing to P0_R40 to P0_R47 for DAC and P0_R30 to P0_R37 for ADC
   6. Power-up the ADC, DAC and MICBIAS by writing to P0_R120
   7. Apply FSYNC and BCLK with the desired output sample rates and the BCLK to FSYNC ratio

      This specific step can be done at any point in the sequence after step a.

      See the Section 7.3.2 section for supported sample rates and the BCLK to FSYNC ratio.

   8. The device recording data is now sent to the host processor using the TDM audio serial data bus and playback data from TDM is now played on the lineout
3. Transition from active mode to sleep mode (again) as required in the system for low-power operation:
   1. Enter sleep mode by writing to P0_R2 to enable sleep mode
   2. Wait at least 10ms (when FSYNC = 48kHz) for the volume to ramp down and for all blocks to power down
   3. Read P0_R122 to check the device shutdown and sleep mode status
   4. If the device P0_R122_D[7:5] status bit is 3'b100 then stop FSYNC and BCLK in the system
   5. The device now goes into sleep mode (low-power mode < 10µA) and retains all register values
4. Transition from sleep mode to active mode (again) as required for the recording operation:
   1. Wake up the device by writing to P0_R2 to disable sleep mode
   2. Wait at least 2ms to allow the device to complete the internal wake-up sequence
   3. Apply FSYNC and BCLK with the desired output sample rates and the BCLK to FSYNC ratio
   4. The device recording data is now sent to the host processor using the TDM audio serial data bus and playback data from TDM is now played on the lineout
5. Repeat the steps as required for different device configurations and modes of operation