SSTX1P/N, SSRX1P/N, SSTX2P/N, SSRX2P/N, CRX1P/N, CRX2PN, CTX1P/N, and CTX2P/N
pairs should be routed with controlled 90-Ω differential impedance (±10%).
There is
no inter-pair length match requirement.
Keep away from other high speed
signals.
Intra-pair routing (between P and
N) should be kept to less than 5 mils.
Length matching should be near
the location of mismatch.
Each pair should be separated at
least by 3 times the signal trace width.
The use of bends in differential
traces should be kept to a minimum. When bends are used, the number of left and
right bends should be as equal as possible and the angle of the bend should be ≥
135 degrees. This will minimize any length mismatch caused by the bends and
therefore minimize the impact bends have on EMI.
Route all differential pairs on
the same of layer.
The number of vias should be kept
to a minimum. It is recommended to keep the vias count to 2 or less.
Keep traces on layers adjacent to
ground plane.
Do not route differential pairs
over any plane split.
Adding test points will cause
impedance discontinuity, and therefore, negatively impact signal performance. If
test points are used, they should be placed in series and symmetrically. They
must not be placed in a manner that causes a stub on the differential pair.
Highly recommended to have reference plane void under USB-C
receptacle's super speed pins to minimize the capacitance effect of the
receptacle.
Highly recommended to have reference plane void under the AC-coupling capacitances.