SBOU297B April   2024  – September 2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Additional Images
    2. 2.2 How to Setup
    3. 2.3 Assembly Instructions
    4. 2.4 Power Requirements
    5. 2.5 Setup
    6. 2.6 Header Information
    7. 2.7 Interfaces
    8. 2.8 Best Practices
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1. 4.1 Trademarks
  10. 5Revision History

Interfaces

The AMP-PDK-EVM has hardware interfaces between the AMP-PDK-EVM, the daughtercard, and the device as seen earlier in Figure 1-1. The daughtercard can only be plugged in one way due to the metal alignment poles. The device can be plugged in several directions, therefore TI recommends to reference the figures below. Single channel daughtercards have a shutdown enable option via a header on the top right of the board. Refer to the corresponding device data sheet to determine which configuration to set the two-pin jumper to enable or disable shutdown mode.

AMP-PDK-EVM AMP-PDK-VSSOP-8 - Pin 1
                    Orientation Example Figure 2-19 AMP-PDK-VSSOP-8 - Pin 1 Orientation Example
AMP-PDK-EVM AMP-PDK-SOIC-14 - Pin 1 -
                    Orientation Example Figure 2-20 AMP-PDK-SOIC-14 - Pin 1 - Orientation Example
AMP-PDK-EVM AMP-PDK-SC70-6 - Pin 1 - Orientation ExampleFigure 2-21 AMP-PDK-SC70-6 - Pin 1 - Orientation Example
AMP-PDK-EVM AMP-PDK-SOT23-6 - Pin 1 - Orientation ExampleFigure 2-22 AMP-PDK-SOT23-6 - Pin 1 - Orientation Example
AMP-PDK-EVM AMP-PDK-SOIC-8 - Pin 1 - Orientation ExampleFigure 2-23 AMP-PDK-SOIC-8 - Pin 1 - Orientation Example
AMP-PDK-EVM AMP-PDK-TSSOP-14 - Pin 1 - Orientation ExampleFigure 2-24 AMP-PDK-TSSOP-14 - Pin 1 - Orientation Example