SLAU936 August   2024 TAS2120

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Quick Start Guide
    1. 2.1 TAS2120EVM Setup for Software Mode
    2. 2.2 TAS2120EVM Setup for Hardware Mode
  9. 3Hardware
    1. 3.1  AC-MB Settings
      1. 3.1.1 Audio Serial Interface Settings
      2. 3.1.2 USB Audio AC-MB Settings
      3. 3.1.3 External Audio AC-MB Settings
    2. 3.2  AC-MB Power Supply
    3. 3.3  Default Jumper Setting on TAS2120EVM
    4. 3.4  I2C Target Address Selection
    5. 3.5  IOVDD Power Supply Options
    6. 3.6  AVDD Power Supply Options
    7. 3.7  VBAT Power Supply Options
      1. 3.7.1 VBAT 3S EVM Hardware Configuration
    8. 3.8  IOVDD_BUFF Power Supply Options
    9. 3.9  Speaker Outputs
    10. 3.10 2-Channel Configuration
    11. 3.11 4-Wire Measurement of Load
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1. 5.1 Trademarks

3.5 IOVDD Power Supply Options

IOVDD supply to TAS2120 is powered by AC-MB through IOVDD_MB selection. For simplicity, the same IOVDD voltage selected on AC-MB is used for TAS2120.

J3 on the bottom side of the EVM can be used to open this power supply connection for current measurement purposes. If J3 is open, then an external IOVDD must be connected to the IOVDD test point close to TAS2120 - U1.