SLOU582 September   2024

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Pin Specifications
    2. 2.2 Power Requirements
    3. 2.3 Input Connectors
    4. 2.4 Output Connectors
    5. 2.5 Onboard Bandpass Filter
    6. 2.6 LNA and AFE Enable/Disable
    7. 2.7 Offset Cancellation And Log In- Cap Capacitor Value Selection
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1. 4.1 Trademarks

1.4 Device Information

The LOG300 is an integrated low-noise amplifier (LNA) + log detector analog front end (AFE). This device supports an input frequency range of 100Hz to 80MHz and a typical dynamic range of 97dB. The is intended for use in applications that require a wide dynamic range of voltage and signal measurement. The low input noise and high sensitivity of the integrated LNA, allows voltage measurement of signals as low as 4 µVrms up to 1.4 Vrms. The transient output response can be adjusted by tuning of the capacitor and the resistor connected at the log o/p pin. The LOG300 is available in a 16-pin SOIC and 16-pin VQFN package. The LOG300 is operational from a 3V to 5V supply and over the full ambient temperature range of –40°C to +125°C.