SLUUB60B May   2015  – August 2021 TPS544B25 , TPS544C25

 

  1.   Trademarks
  2. 1 Introduction
  3. 2 Description
    1. 2.1 Typical End-User Applications
    2. 2.2 EVM Features
  4. 3 EVM Electrical Performance Specifications
  5. 4 Schematic
  6. 5 Test Setup
    1. 5.1 Test and Configuration Software
      1. 5.1.1 Description
      2. 5.1.2 Features
    2. 5.2 Test Equipment
    3. 5.3 The PWR-681EVM
    4. 5.4 List of Test Points, Jumpers ans Switch
  7. 6 EVM Configuration Using the Fusion GUI
    1. 6.1 Configuration Procedure
  8. 7 Test Procedure
    1. 7.1 Line/Load Regulation Measurement Procedure
    2. 7.2 Efficiency
    3. 7.3 Bode Plot Measurement Procedure
    4. 7.4 Equipment Shutdown
  9. 8 Performance Data and Typical Characteristic Curves
    1. 8.1  Efficiency
    2. 8.2  Load Regulation
    3. 8.3  Line Regulation
    4. 8.4  Transient Response
    5. 8.5  Output Ripple
    6. 8.6  Control On
    7. 8.7  Control Off
    8. 8.8  Overcurrent Protection
    9. 8.9  Control Loop Bode Plot
    10. 8.10 Thermal Image
  10. 9 Fusion GUI
  11. 10EVM Assembly Drawing and PCB Layout
  12. 11List of Materials
  13. 12Revision History

8.8 Overcurrent Protection

GUID-F223BCF9-E376-4EA9-B44C-B562632F6D2F-low.png
Ch1 = VIN at 10 V/division, Ch2 = IIN at 2 A/division, Ch3 = VOUT at 500 mV/division, Ch4 = IOUT at 10 A/division
Figure 8-10 Overcurrent Protection, 0.95-V Output at 12 VIN, 36-A Output
GUID-2F9BD958-4651-4D54-8DE1-88A18D37F953-low.png
Ch1 = VIN at 10 V/division, Ch2 = IIN at 2 A/division, Ch3 = VOUT at 500 mV/division, Ch4 = IOUT at 10 A/division
Figure 8-11 Restart from Overcurrent Protection, 0.95-V Output at 12 VIN