SLUUC03A February   2019  – December 2022 TPS566235

 

  1.   TPS566235EVM-036 evaluation module
  2.   Trademarks
  3. 1Introduction
  4. 2Specification Summary
  5. 3Modifications
    1. 3.1 Output Voltage Setpoint
    2. 3.2 Mode Selection
  6. 4Schematic and Board layout
    1. 4.1 Schematic
    2. 4.2 Board Layout
  7. 5EVM Test Setup
    1. 5.1 Connectors and Jumpers Description and Placement
    2. 5.2 Start-up Procedure
  8. 6Test Waveforms
    1. 6.1 Power Up
    2. 6.2 Power Down
    3. 6.3 Output Voltage Ripple
    4. 6.4 Load Transient Response
    5. 6.5 Thermal
  9. 7List of Materials and Reference
    1. 7.1 List of Materials
    2. 7.2 Reference
  10. 8Revision History

Mode Selection

TPS566235 has a MODE pin to select 3 different operation mode at light load. The device reads the voltage on MODE pin during start-up and latches onto one of the MODE options listed below in Table 3-1.

Table 3-1 MODE Pin Resistor Setting
VMODERECOMMENDED MODE RESISTOR RMOPERATION MODE
0 - 0.3 V0 ΩEco-Mode
0.3 V - 1.2 V100 kΩ - 150 kΩOut-of-Audio (OOA)
> 1.2 VConnected to VCC pin (recommend) or > 400 kΩForced CCM (FCCM)

Changing the position of jumper on J3 can modify MODE pin configuration before power on.