SLUUC51D june   2020  – july 2023 BQ25790

 

  1.   1
  2.   BQ25790EVM (BMS027) Evaluation Module User's Guide
  3.   Trademarks
  4.   4
  5. 1Introduction
    1. 1.1 EVM Features
    2. 1.2 I/O Descriptions
    3. 1.3 Recommended Operating Conditions
  6. 2Test Setup and Results
    1. 2.1 Equipment
    2. 2.2 Equipment Setup
    3. 2.3 Software Setup
      1. 2.3.1 BQSTUDIO using EV2400
      2. 2.3.2 TI Charger GUI for USB2ANY
    4. 2.4 Test Procedure
      1. 2.4.1 Initial Settings
      2. 2.4.2 Communication Verification
      3. 2.4.3 Charge Mode Verification
      4. 2.4.4 OTG Mode Verification
  7. 3PCB Layout Guidelines
  8. 4Board Layout, Schematic and Bill of Materials
    1. 4.1 Schematic
    2. 4.2 Board Layout
    3. 4.3 Bill of Materials
  9. 5Revision History

5 Revision History

Changes from Revision C (July 2022) to Revision D (July 2023)

Changes from Revision B (March 2022) to Revision C (July 2022)

  • Changed Equipment sectionGo
  • Changed Figure 2-1 Go
  • Added section about using a USB2ANY device. Changed section on BQStudio to tell the user to change input boxes instead of putting in binary numbers into the register window.Go
  • Changed Communication Verification sectionGo
  • Changed Charge Mode Verification sectionGo
  • Changed OTG Mode Verification sectionGo

Changes from Revision A (July 2020) to Revision B (March 2022)

Changes from Revision * (June 2020) to Revision A (July 2020)