SLVUBU6A April   2020  – June 2020 TPS274160

 

  1.   TPS274160 Evaluation Module User's Guide
    1.     Trademarks
    2. 1 Introduction
      1. 1.1 Description
      2. 1.2 Applications
      3. 1.3 Features
    3. 2 TPS274160 Schematic
    4. 3 Connection Descriptions
      1. 3.1 Connectors
      2. 3.2 Jumpers
    5. 4 TPS274160 EVM Assembly Drawings and Layout
    6. 5 Variable Resistor for CS and CL
      1. 5.1 Current Sense Resistor
      2. 5.2 Current Limit Resistor
    7. 6 Bill of Materials
  2.   Revision History

3.1 Connectors

VS – The board's positive input supply voltage connector, the drain terminal of DMOS.

GND – The board's GND connector, the return connection to the input power supply.

EN1 – The board's input connector; controls CH1 output. 3.3-V or 5-V control signal connection pin.

EN2 – The board's input connector; controls CH2 output. 3.3-V or 5-V control signal connection pin.

EN3 – The board's input connector; controls CH3 output. 3.3-V or 5-V control signal connection pin.

EN4 – The board's input connector; controls CH4 output. 3.3-V or 5-V control signal connection pin.

OUT1 – The board's CH1 output pin connector, the source terminal of DMOS.

OUT2 – The board's CH2 output pin connector, the source terminal of DMOS.

OUT3 – The board's CH3 output pin connector, the source terminal of DMOS.

OUT4 – The board's CH4 output pin connector, the source terminal of DMOS.

ST1 – The board's CH1 status output connector, only effective for version A.

ST2 – The board's CH2 status output connector, only effective for version A.

ST3 – The board's CH3 status output connector, only effective for version A.

ST4 – The board's CH4 status output connector, only effective for version A.

SEH – The high-bit channel selection connector, combining with SEL to select which channel CS pin sense for, only effective for version B.

SEL – This is the low-bit channel selection connector, combining with SEH to select which channel CS pin sense for, only effective for version B.

FAULT – The board's states report connector, only effective for version B, can get the OR value for 4-CHs fault.

CS – The board's current sense output connector, only effective for version B.

CL – The board's current limit output connector.

DIAG_EN – The board's DIAG_EN input connector, 3.3-V or 5-V control signal connection pin.

THER – This is the thermal shutdown behavior control connector.