SLVUCZ2 May   2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Headers and Test Points Information
    2. 2.2 Connector Information
    3. 2.3 Indicator LEDs
    4. 2.4 Hardware Setup
  9. 3Software
    1. 3.1 Web GUI Access or Local GUI Installation
    2. 3.2 Connecting EVM to GUI
    3. 3.3 GUI Overview
    4. 3.4 DRV8000-Q1EVM
      1. 3.4.1 Register Map
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1. 5.1 Trademarks

3.4 DRV8000-Q1EVM

The DRV8000-Q1EVM GUIs has five main pages: Half Bridge Controls, High Side Driver Controls, EC and Heater Controls, Gate Driver Controls and Register Map. Each controls page gives the important register settings and hardware control to configure the respective peripheral. Each page does not offer all the controls for the peripheral; for full control, the Register Map page is recommended after setting basic configurations in the controls page. There is also a IPROPI & Diagnostics panel that can be expanded from any GUI screen.

Access the IPROPI & Diagnostics pane at any time by clicking the blue control on the right side of the screen. Figure 4-6 below shows the pane opened.

DRV8000-Q1EVM, Driver Control PanelFigure 3-6 Driver Control Panel