SNAU246A June   2020  – January 2021 LMX2820

 

  1. 1Trademarks
  2. 2LMX2820EVM Evaluation Module
    1. 2.1 Evaluation Module Contents
    2. 2.2 Evaluation Setup Requirement
    3. 2.3 Resources
  3. 3Setup
    1. 3.1 Connection Diagram
    2. 3.2 Power Supply
    3. 3.3 Reference Clock
    4. 3.4 RF Output
    5. 3.5 Programming
    6. 3.6 Evaluation Software
  4. 4Typical Measurement
    1. 4.1 Default Configuration
      1. 4.1.1 Loop Filter
      2. 4.1.2 Typical Output
    2. 4.2 Additional Tests
      1. 4.2.1 SYSREF Example
      2. 4.2.2 Offset Mixing With PFDIN Pin
      3. 4.2.3 External VCO Mode
      4. 4.2.4 Register Readback
  5. 5Schematic
  6. 6PCB Layout and Layer Stack-Up
    1. 6.1 PCB Layer Stack-Up
    2. 6.2 PCB Layout
  7. 7Bill of Materials
  8. 8Troubleshooting Guide
    1.     A Using Different Reference Clock
      1.      B USB2ANY Firmware Upgrade
        1.       C Revision History

Programming

Connect the ribbon cable from the USB2ANY to the LMX2820EVM.

Connect the USB cable from a PC to USB port in the USB2ANY. This provides power supply to the USB2ANY and communication with the TICS Pro. A firmware update may be required. See Section B for more details.