SNLU223D August   2017  – February 2023 DS90UB954-Q1

1.   DS90UB954-Q1EVM Deserializer User's Guide
2. 1 Trademarks
3. 2 Introduction
4. 3 Quick Start Guide
   1. 3.1 System Requirements
      1. 3.1.1 Included Components
      2. 3.1.2 Additional Required Components
   2. 3.2 Applications Diagram
   3. 3.3 Major Components of DS90UB954-Q1EVM
   4. 3.4 DS90UB954-Q1EVM Setup
5. 4 DS90UB954-Q1EVM Board Configuration
   1. 4.1 Default Configuration
   2. 4.2 Power Supply
   3. 4.3 Power-over-Coax Interface
   4. 4.4 MIPI CSI-2 Output Signals
   5. 4.5 FPD-Link III Signals
   6. 4.6 I2C Interface
   7. 4.7 Control Interface
6. 5 Enable and Reset
7. 6 Use with DS90UB936-Q1
8. 7 Typical Connection and Test Equipment
9. 8 Termination Device
10. 9 Typical Test Setup
11. 10Equipment References
12. 11Cable References
13. 12Software for DS90UB954Q1-EVM Evaluation - Analog LaunchPAD (ALP) Software Setup
    1. 12.1 System Requirements
    2. 12.2 Download Contents
    3. 12.3 Installation of the ALP Software
    4. 12.4 Startup - First Launch
14. 13Using ALP and DS90UB954 Profile
    1. 13.1 Information Tab
    2. 13.2 Registers Tab
    3. 13.3 Registers Tab - Address 0x00 Expanded
       1. 13.3.1 Port Specific Registers
       2. 13.3.2 36
    4. 13.4 Saving and Loading Register Settings
    5. 13.5 Scripting Tab
       1. 13.5.1 Example Functions
          1. 13.5.1.1 Local I2C Reads/Writes
          2. 13.5.1.2 General I2C Reads/Writes:
          3. 13.5.1.3 I2C Reads/Writes with Multi-Byte Register Addresses
    6. 13.6 GPIO Tab
    7. 13.7 Forwarding Tab
    8. 13.8 CSI Registers Tab
    9. 13.9 Remote Registers Tab
15. 14Troubleshooting ALP Software
    1. 14.1 ALP Does Not Detect The EVM
    2. 14.2 USB2ANY Firmware Issues
16. 15DS90UB954-Q1EVM PCB Schematics, Layout and Bill of Materials - DS90UB954-Q1EVM Schematic
17. 16DS90UB954-Q1 EVM PCB Layout
18. 17DS90UB954-Q1EVM Bill of Materials
19. 18Revision History