SNVU879 June   2024 LMR36503E-Q1

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 EVM Setup
      1. 2.1.1 Quick Start
      2. 2.1.2 Test Points
      3. 2.1.3 Jumpers
  9. 3Implementation Results
    1. 3.1 Performance Data and Results
      1. 3.1.1 Efficiency, Load Regulation, and Dropout
      2. 3.1.2 Load Transients
      3. 3.1.3 Steady State
      4. 3.1.4 Line Transient
    2. 3.2 Thermal Images
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 Board Layout
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1. 5.1 Trademarks

2.1.2 Test Points

The test points on the top of the board can be used for connecting to the input and output of the EVM. See Table 3-1 for a description of the test points.

Table 2-1 EVM Test Points
Test PointSignalDescription

J1

VIN_EMI

Input supply to EVM including an EMI filter. Connect to a good input supply. Connect at this point for conducted EMI test.
GND_EMIGround connection for the input supply

TP1

VIN

Input supply to the IC. Can be connected to DMM to measure input voltage after EMI filter
TP2, TP3VOUTOutput voltage test point of EVM. Can be connected to a desired load
TP4, TP5, TP6, TP7, TP11GNDGround connection for the input supply as well as test points for ground connection
TP8PGOODThis test point is connected to the PGOOD pin from the IC. The test point is an open-drain output of the PGOOD pin. Using the jumper J3, the PGOOD pin can be tied to external supply through a pullup resistor or left open.

TP9

SYNCIn a MODE/SYNC trim part, this test point is connected to the SYNC pin of the IC. The test point can operate in user-selectable PFM/FPWM mode and can be connected to an external clock to synchronize the IC. Make sure R7 (RMODE) is installed and R5 (RT) is not installed.
In a RT trim part, this test point is connected to the RT pin of the IC when the R4 (RMODE) is installed.
TP10ENThis test point is connected to the EN pin. By default, there is a pullup resistor R2 to VIN to enable the IC.