SPRAD34B July   2023  – October 2023 MSPM0G1507

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
  5. 2Getting Started With MSPM0 Motor Control
  6. 3Brushed-DC Motor Control
    1. 3.1 Background
    2. 3.2 Software Architecture
    3. 3.3 Block Diagrams
      1. 3.3.1 H-Bridge Motor Driver
      2. 3.3.2 H-Bridge Gate Driver
    4. 3.4 Hardware Support
    5. 3.5 Software Support
    6. 3.6 Evaluating Brushed-DC with MSP Motor Control SDK
  7. 4Stepper Motor Control
    1. 4.1 Background
    2. 4.2 Software Architecture
    3. 4.3 Block Diagrams
    4. 4.4 Hardware Support
    5. 4.5 Software Support
    6. 4.6 Evaluating Stepper With MSP Motor Control SDK
  8. 5BLDC Sensored Trap Control
    1. 5.1 Background
    2. 5.2 Software Architecture
    3. 5.3 Block Diagrams
    4. 5.4 Hardware Support
    5. 5.5 Software Support
    6. 5.6 Evaluating Sensored Trap with MSP Motor Control
  9. 63-Phase Sensorless FOC Control
    1. 6.1 Background
    2. 6.2 Software Architecture
    3. 6.3 Block Diagrams
      1. 6.3.1 MSPM0Gx10x and Gate Driver with Analog/MOSFET Integration
      2. 6.3.2 MSPM0Gx50x Analog Integration and Gate Driver
    4. 6.4 Hardware Support
    5. 6.5 Software Support
    6. 6.6 Evaluating Sensorless FOC with MSP Motor Control
    7. 6.7 Sensorless FOC Performance
  10. 7References
  11.   Revision History

3.3 Block Diagrams

The block diagrams showcase supported MSPM0L1xxx designs for Brushed DC motors in the Brushed Motor Control examples.

  • 2-PWM control interface (PWM)
  • Phase-Enable interface (PH/EN)
  • Half-bridge control
  • Independent mode control

The two topologies that are supported are H-Bridge Motor Driver and H-Bridge Gate Driver.