SPRUIT8D February   2020  – February 2021 AWR2243

 

  1.   Trademarks
  2. 1Getting Started
    1. 1.1 Introduction
    2. 1.2 Key Features
    3. 1.3 What is Included
      1. 1.3.1 Kit Contents
      2. 1.3.2 mmWave Proximity Demo
  3. 2Hardware
    1. 2.1 Block Diagram
    2. 2.2 Connecting BoosterPack™ to LaunchPad™ or MMWAVE-DEVPACK
    3. 2.3 Power Connections
    4. 2.4 Connectors
      1. 2.4.1 20-Pin BoosterPack™ Connectors
      2. 2.4.2 60-Pin High Density (HD) Connector
    5. 2.5 PC Connection
      1. 2.5.1 Erasing Onboard Serial Flash
      2. 2.5.2 Connection With MMWAVE-DEVPACK
      3. 2.5.3 Connecting the BoosterPack to the DCA1000
    6. 2.6 Antenna
    7. 2.7 Jumpers, Switches, and LEDs
      1. 2.7.1 Sense On Power Jumpers
      2. 2.7.2 Current Measurement
      3. 2.7.3 Push Buttons and LEDs
      4. 2.7.4 Selection Between SPI and CAN Interface
  4. 3Design Files and Software Tools
    1. 3.1 LDO Bypass Requirement
  5. 4Design Revision History
  6. 5Mechanical Mounting of PCB
  7. 6PCB Storage and Handling Recommendations
  8. 7Regulatory Information
  9. 8Revision History

2.1 Block Diagram

GUID-008E1292-50A4-4264-928A-7B636EC07AA7-low.png Figure 2-3 BoosterPack™ Block Diagram
Note: The AWR2243 does not support CAN communication. Because the AWR2243BOOST shares the same PCB as the AWR1443BOOST, the PCB contains a CAN connector (J3) and CAN PHY (U3); however, the connector and PHY are not functional. The SPI/CAN selector switch (refer to Section 2.7.4 for more details) should always be set to ‘SPI’ mode on the AWR2243BOOST.