SPRUJ73 December   2023

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
      1. 1.1.1 Read This First
        1. 1.1.1.1 Sitara MCU+ Academy
        2. 1.1.1.2 Important Usage Notes
    2. 1.2 Kit Contents
  6. 2Hardware Description
    1. 2.1 Component Identification
    2. 2.2 Power Requirements
      1. 2.2.1 Power Input Using USB Type-C Connector
      2. 2.2.2 Power Status LEDs
      3. 2.2.3 Power Tree
    3. 2.3 Functional Block Diagram
    4. 2.4 Header Information
    5. 2.5 Interfaces
      1. 2.5.1 ADC
      2. 2.5.2 LIN
      3. 2.5.3 MCAN
      4. 2.5.4 TRACE/GPMC Muxing Scheme
      5. 2.5.5 GPMC Memory Interface
        1. 2.5.5.1 PSRAM
        2. 2.5.5.2 GPMC Memory Footprint
        3. 2.5.5.3 NOR FLASH
      6. 2.5.6 TI 14-Pin Header
      7. 2.5.7 MIPI-60 Connector
    6. 2.6 HSEC Pinout
  7. 3Additional Information
    1. 3.1 If You Need Assistance
    2.     Trademarks
  8. 4References
    1. 4.1 Reference Documents
    2. 4.2 Other TI Components Used in This Design
  9. 5Revision History

1.1 Introduction

The AM263x controlCARD Docking Station was developed to expand on the capabilities of the AM263x controlCARD and AM263Px controlCARD Evaluation Modules (EVM), and enable easy and rapid prototyping of the AM263x/AM263Px and their peripherals. There are several on-board transceivers and PHYs to enable the many interfaces of the AM263x and AM263Px SoC (System on a Chip). This user's guide details the design of the EVM and how to properly use each interface. The user's guide also details many important aspects of the board including but not limited to pin header descriptions, test points, and mux/switch signal routing.