SPRUJ85A April   2024  – August 2024

PRODUCTION DATA  

1.   1
2.   Description
3. 1Key Features
4. 2LaunchPad Module Overview
   1. 3.1 Introduction
   2. 3.2 Preface: Read This First
      1. 3.2.1 If You Need Assistance
      2. 3.2.2 Important Usage Notes
   3. 3.3 Kit Contents
   4. 3.4 Device Information
      1. 3.4.1 System Architecture Overview
      2. 3.4.2 Security
      3. 3.4.3 Compliance
      4. 3.4.4 BoosterPacks
      5. 3.4.5 Component Identification
5. 3Hardware Description
   1. 4.1  Board Setup
      1. 4.1.1 Power Requirements
         1. 4.1.1.1 Power Input Using USB Type-C Connector
         2. 4.1.1.2 Power Status LEDs
         3. 4.1.1.3 Power Tree
      2. 4.1.2 Push Buttons
      3. 4.1.3 Boot mode Selection
      4. 4.1.4 IO Expander
   2. 4.2  Functional Block Diagram
   3. 4.3  GPIO Mapping
   4. 4.4  Reset
   5. 4.5  Clock
   6. 4.6  Memory Interfaces
      1. 4.6.1 OSPI
      2. 4.6.2 MMC
      3. 4.6.3 eMMC
      4. 4.6.4 Board ID EEPROM
   7. 4.7  Ethernet Interface
      1. 4.7.1 Ethernet PHY #1 - CPSW RGMII/ICSSM
      2. 4.7.2 Ethernet PHY #2 - CPSW RGMII/ICSSM
      3. 4.7.3 LED Indication in RJ45 Connector
   8. 4.8  I2C
   9. 4.9  Industrial Application LEDs
   10. 4.10 SPI
   11. 4.11 UART
   12. 4.12 MCAN
   13. 4.13 FSI
   14. 4.14 JTAG
   15. 4.15 TIVA and Test Automation Header
   16. 4.16 LIN
   17. 4.17 ADC and DAC
   18. 4.18 EQEP and SDFM
   19. 4.19 EPWM
   20. 4.20 BoosterPack Headers
   21. 4.21 Pinmux Mapping
6. 4Additional Information
   1.     Trademarks
   2. 5.1 Sitara MCU+ Academy
   3. 5.2 Known Board Changes/Issues
      1. 5.2.1 OSPI DQS and LBCLK nets swap
      2. 5.2.2 XDS110 Debugger Bricking Issue
      3. 5.2.3 eMMC CMD and CLK nets swap
7. 5References
   1. 6.1 Reference Documents
   2. 6.2 Other TI Components Used in This Design
8. 6Revision History