SPRUJE8 December   2024 AM2754-Q1

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Preface Read This First
      1. 1.2.1 Important Usage Notes
    3. 1.3 Kit Contents
    4. 1.4 Device Information
      1. 1.4.1 Security
    5. 1.5 Audio Expansion Connectors
  6. 2Hardware
    1. 2.1  Component Identification
    2. 2.2  Power Requirements
      1. 2.2.1 Power Input Using USB Type-C Connector
      2. 2.2.2 Power Status LEDs
      3. 2.2.3 Power Tree
      4. 2.2.4 Power Sequence
      5. 2.2.5 PMIC
    3. 2.3  Reset
    4. 2.4  Clock
    5. 2.5  Boot Mode Selection
    6. 2.6  Header Information
    7. 2.7  Push Buttons
    8. 2.8  Switches
    9. 2.9  Interfaces
      1. 2.9.1 Ethernet Interface
        1. 2.9.1.1 Ethernet Add-on Connectors
      2. 2.9.2 Audio Interfaces
        1. 2.9.2.1 Audio Clocking
        2. 2.9.2.2 McASP
        3. 2.9.2.3 MLB
    10. 2.10 AEC Mapping
      1. 2.10.1 Audio Expansion Connector 1
      2. 2.10.2 Audio Expansion Connector 2
    11. 2.11 Test Points
  7. 3Hardware Design Files
  8. 4Additional Information
    1. 4.1 If You need Assistance
    2. 4.2 Trademarks
  9. 5References
    1. 5.1 Reference Documents
    2. 5.2 Other TI Components Used This Design
  10. 6Revision History

2.8 Switches

SW9 dictates routing logic of MMC0 IO to eMMC or SDcard.

Table 2-12 SW9 Position Table
Switch position MMC0 Routing
ON uSD Interface
OFF eMMC Interface

SW11 dictates which reference 1.8V the AM275x ADC0 uses: VDDA_1V8 PMIC analog output, or an external 1.8V reference from Header J31(Pin 2)

Table 2-13 SW11 Position Table
Switch position ADC Reference Source
SW11 Position 1-2 VDDA_1V8
SW11 Position 3-2 ADC0_REFP_HDR (External Reference from J31)