SWRA750 September   2022

 

  1.   Introduction
  2.   Trademarks
  3. 1Connectionless RF Tests
    1. 1.1 Continuous TX
    2. 1.2 Tester Packet TX RX
    3. 1.3 Continuous RX
    4. 1.4 BER Meter Test
      1. 1.4.1 BER Test - Between Two WiLink Devices
      2. 1.4.2 BER Test - Between WiLink (RX) and Litepoint iQ2010 (TX)
  4. 2Bluetooth SIG RF Test Mode
  5. 3Bluetooth Low Energy Testing
  6. 4Connection Test
  7. 5Conversion of HCI Commands to SS1Tool or hcitool Format
    1. 5.1 Examples of SS1Tool or Enhanced Bluetopia PM Test Format Conversion
      1. 5.1.1 Connectionless RF Tests
        1. 5.1.1.1 Continuous TX
        2. 5.1.1.2 Packet TX RX
        3. 5.1.1.3 Continuous RX
        4. 5.1.1.4 RX BER Meter Test
      2. 5.1.2 Bluetooth SIG RF Test Mode
      3. 5.1.3 Bluetooth Low Energy Testing
  8. 6Revision History

5.1.3 Bluetooth Low Energy Testing

Transmitter Test

HCI Tester command format

Send_HCI_VS_DRPb_Enable_RF_Calibration_Enhanced 0xFDFB, 0x1, 0xFF, 0x80000000, 0x00 //disable RF Calibration
Send_HCI_BLE_Transmitter_Test 0x201e, 0x00, 0x00, 0
Send_HCI_BLE_Test_End 0x201f

Bluetopia HCI tool format:

SS1Tool cmd 0x3f 0x01fb 0x01 0xff 0x00 0x00 0x00 0x80 0x00 //disable RF Calibration
SS1Tool cmd 0x08 0x001e 0x00 0x00 0x00
SS1Tool cmd 0x08 0x001f

Receiver Test

HCI Tester command format

Send_HCI_VS_DRPb_Enable_RF_Calibration_Enhanced 0xFDFB, 0x1, 0xFF, 0x80000000, 0x00 //disable RF Calibration
Send_HCI_BLE_Receiver_Test 0x201d, 0x00
Send_HCI_BLE_Test_End 0x201f

Bluetopia HCI tool format:

SS1Tool cmd 0x3f 0x01fb 0x01 0xff 0x00 0x00 0x00 0x80 0x00 //disable RF Calibration
SS1Tool cmd 0x08 0x001d 0x00
SS1Tool cmd 0x08 0x001f