SWRU630 December   2024 AWRL6844 , IWRL6844

 

  1.   1
  2.   Description
  3.   Getting Started
  4.   Features
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Key Features
    3. 1.3 Kit Contents
    4. 1.4 Specification
    5. 1.5 Device Information
  6. 2Hardware
    1. 2.1  xWRL6844EVM Antenna
      1. 2.1.1 PCB Material
        1. 2.1.1.1 Transmitter and Receiver Virtual Array
    2. 2.2  EVM Mux Block Diagram
    3. 2.3  Switch Settings
    4. 2.4  Push Button Switches
    5. 2.5  LEDs
    6. 2.6  DC Input Jack
    7. 2.7  USB Connector
    8. 2.8  DCA1000 HD Connector
    9. 2.9  BoosterPack Connector for LaunchPad Connectivity
    10. 2.10 CAN-FD_B Connector
    11. 2.11 CAN-FD_A Connector
    12. 2.12 LIN-PHY Connector
    13. 2.13 I2C Connections
      1. 2.13.1 EEPROM
    14. 2.14 XDS110 Interface
    15. 2.15 FTDI Interface
    16. 2.16 DCA1000EVM Mode
    17. 2.17 PCB Storage and Handling Recommendations:
      1. 2.17.1 PCB Storage and Handling Recommendations
      2. 2.17.2 Higher Power Demanding Applications
  7. 3Software, Development Tools, and Example Code
  8. 4Hardware Design Files
    1. 4.1 Schematics, PCB Layout and Bill of Materials (BOM)
    2. 4.2 EVM Design Database
    3. 4.3 Hardware Design Checklist
  9. 5Additional Information
    1. 5.1 Trademarks
  10. 6References
    1. 6.1 TI E2E Community
  11. 7Revision History

2.13 I2C Connections

The xWRL6844EVM board features a temperature sensor for measuring on-board temperature, current sensors for current measurement on 3.3V, 1.8V, 1.2VDigital, 1.2VRF power supply rails for xWRL6844 device and EEPROM for storing board ID. These are connected to TPS65036501 and xWRL6844 through I2C bus. In addition to this, header J1 is also provided for easy interface to I2C bus. Please refer to xWRL6844EVM's schematics for the I2C addresses.

AWRL6844EVM IWRL6844EVM I2C Connector Figure 2-27 I2C Connector