SWRU631 November   2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 PCB Handling Recommendations
    2. 2.2 Power Connections
    3. 2.3 Connectors
      1. 2.3.1 MIPI 60-Pin Connector (J19)
        1. 2.3.1.1 MIPI TRACE ECO List
      2. 2.3.2 Debug Connector-60 pin (J7)
        1. 2.3.2.1 CSI2 FE Connector ECO List
      3. 2.3.3 Ethernet Ports (J4 and J9)
        1. 2.3.3.1 ECOs to Enable the DP83TG720S-Q1 PHY
      4. 2.3.4 USB Connectors (J8, J10)
      5. 2.3.5 OSC_CLK_OUT Connector (J2)
      6. 2.3.6 Voltage Rails Ripple Measurement Connectors (J1, J3, J5) (DNP)
    4. 2.4 Antenna
    5. 2.5 PMIC
    6. 2.6 On-Board Sensors
    7. 2.7 PC Connection
      1. 2.7.1 XDS110 Interface
      2. 2.7.2 FTDI Interface
    8. 2.8 Connecting the AWR2E44PEVM to the DCA1000 EVM
    9. 2.9 Jumpers, Switches, and LEDs
      1. 2.9.1 Switches
      2. 2.9.2 Sense On Power (SOP) Jumpers (J17, J18, J20)
      3. 2.9.3 I2C Connections
      4. 2.9.4 Push Buttons
      5. 2.9.5 LEDs
  8. 3Software
    1. 3.1 Software, Development Tools, and Example Code
  9. 4Hardware Design Files
    1. 4.1 Design Files
  10. 5Additional Information
    1.     Trademarks
  11. 6Revision History

2.9.4 Push Buttons

Table 2-12 Push Button Switches
ReferenceUsageComments
SW1RESET

This Switch is used to RESET the AWR2E44P, PMIC, XDS110 and FTDI device.

SW2GPIO_28When pushed, the GPIO_28 shall be pulled to High.