SBASA11 Data sheet | TI.com

SBASA11B August 2020 – July 2021 AMC3302

PRODUCTION DATA

6.13 Typical Characteristics

at VDD = 3.3 V, INP = –50 mV to +50 mV, INN = HGND = 0 V, and f_IN = 10 kHz (unless otherwise noted)

Figure 6-5 Input Bias Current vs Common-Mode Input Voltage

Figure 6-7 Input Bias Current vs Temperature

Figure 6-9 Output Common-Mode Voltage vs Supply Voltage

Figure 6-11 Normalized Gain vs Input Frequency

Figure 6-13 Output Bandwidth vs Supply Voltage

Figure 6-15 Input Offset Voltage vs Supply Voltage

Figure 6-17 Gain Error vs Supply Voltage

Figure 6-19 Nonlinearity vs Input Voltage

Figure 6-21 Nonlinearity vs Temperature

V_IN = 0.1 V_pp, f_IN = 10 kHz

Figure 6-23 Signal-to-Noise Ratio vs Supply Voltage

Figure 6-25 Total Harmonic Distortion vs Supply Voltage

Figure 6-27 Input-Referred Noise Density vs Frequency

Figure 6-29 Common-Mode Rejection Ratio vs Temperature

Figure 6-31 Supply Current vs Supply Voltage

Figure 6-33 High-Side LDO Line Regulation

Figure 6-35 Output Rise and Fall Time vs Temperature

Figure 6-37 V_IN to V_OUT Signal Delay vs Temperature

Figure 6-6 Input Bias Current vs Supply Voltage

Figure 6-8 Output Voltage vs Input Voltage

Figure 6-10 Output Common-Mode Voltage vs Temperature

Figure 6-12 Output Phase vs Input Frequency

Figure 6-14 Output Bandwidth vs Temperature

Figure 6-16 Input Offset Voltage vs Temperature

Figure 6-18 Gain Error vs Temperature

Figure 6-20 Nonlinearity vs Supply Voltage

V_IN = 0.1 V_pp, f_IN = 10 kHz

Figure 6-22 Signal-to-Noise Ratio vs Input Voltage

V_IN = 0.1 V_pp, f_IN = 10 kHz

Figure 6-24 Signal-to-Noise Ratio vs Temperature

Figure 6-26 Total Harmonic Distortion vs Temperature

Figure 6-28 Common-Mode Rejection Ratio vs Input Frequency

Figure 6-30 Power-Supply Rejection Ratio vs Ripple Frequency

Figure 6-32 Supply Current vs Temperature

Figure 6-34 Output Rise and Fall time vs Supply Voltage

Figure 6-36 V_IN to V_OUT Signal Delay vs Supply Voltage