SBAU294A July   2020  – January 2023 ADC3541 , ADC3542 , ADC3543 , ADC3544

 

  1.   Abstract
  2.   Trademarks
  3. 1Introduction
  4. 2 Equipment
    1. 2.1 Evaluation Board Feature Identification Summary
    2. 2.2 Required Equipment
  5. 3Setup Procedure
    1. 3.1 Install High-Speed Data Converter (HSDC) Pro Software
    2. 3.2 Install the Configuration GUI Software
    3. 3.3 Connect the ADC EVM and TSW1400EVM
    4. 3.4 Connect the Power Supply and Mini-USB Connections
    5. 3.5 Connect Signal Generators to ADC354xEVM
    6. 3.6 Configure HSDC Pro and Capture Data
  6. 4Device Configuration
    1. 4.1 Low Level Control
    2. 4.2 Current Monitoring
  7. 5Troubleshooting
  8. 6References
    1. 6.1 Analog Input Configuration
  9. 7Revision History

5 Troubleshooting

If the ADC354xEVM D1 LED is not illuminated:

  • Ensure J12 jumper is installed (shunt 2-3)
  • Ensure mini-USB cable is securely connected to J19

If HSDC Pro does not successfully capture data:

  • Ensure that the sampling clock is present at J2 of the ADC354xEVM
  • Ensure that the TSW1400EVM has at least 3 A of current available on its 5-V power supply
  • Push the S1 button on the ADC354xEVM to reset ADC, and restore default settings