SBAU376A December   2021  – March 2022 TMAG5328

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Overview
    1. 1.1 Features
  5. 2Kit Contents
  6. 3Related Documentation From Texas Instruments
  7. 4Hardware
    1. 4.1 EVM Threshold Adjustment Options
      1. 4.1.1 Adjusting Threshold With DAC
      2. 4.1.2 Adjusting Threshold With Potentiometer
        1. 4.1.2.1 Using the Potentiometer to Estimate the Magnetic Flux Density Sensed by the TMAG5328
      3. 4.1.3 Adjusting Threshold With Fixed Resistor
    2. 4.2 Power Supply Options and Jumper Settings
  8. 5EVM Operation
    1. 5.1 Evaluation With SCB and GUI
      1. 5.1.1 Driver Installation
      2. 5.1.2 Firmware
        1. 5.1.2.1 Updating Firmware on SCB
      3. 5.1.3 GUI Setup and Usage
        1. 5.1.3.1 Initial Setup
        2. 5.1.3.2 GUI Operation
          1. 5.1.3.2.1 GUI Results Page
          2. 5.1.3.2.2 GUI DAC Configuration Page
      4. 5.1.4 Direct EVM Serial Communication
    2. 5.2 Evaluation Without SCB and GUI (EVM Stand-Alone Mode)
    3. 5.3 Head-On Linear Displacement Demo
  9. 6Schematics, PCB Layout, and Bill of Materials
    1. 6.1 Schematics
    2. 6.2 PCB Layout
    3. 6.3 Bill of Materials
  10. 7Revision History

5.1 Evaluation With SCB and GUI

To use the EVM with the SCB, connect the EVM as shown in Figure 5-1.

GUID-20211108-SS0I-MVK4-NJBC-JRLSCWMGFCZT-low.png Figure 5-1 Sensor Control Board Connected to TMAG5328EVM