SBAU441 March   2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Board Overview
    2. 2.2 Required Equipment
    3. 2.3 Hardware Setup
  9. 3Software
    1. 3.1 Required Software
    2. 3.2 Software Setup
  10. 4Implementation Results
    1. 4.1 Evaluation Setup
    2. 4.2 Data Capture
  11. 5Hardware Design Files
    1. 5.1 Schematics
    2. 5.2 PCB Layouts
    3. 5.3 Bill of Materials (BOM)
  12. 6Additional Information
    1. 6.1 Trademarks
  13. 7References

2.2 Required Equipment

The following equipment is not included with the EVM kit, but is required for proper evaluation.

  • TSW1418EVM FPGA Capture card for capturing data from the ADC
  • At least two low-noise signal generators to provide the ADC sample clock and analog input. TI recommends either of the following signal generators:
    • Rohde & Schwarz SMA100A
    • Rohde & Schwarz SMA100B
  • Bandpass filters for the sample clock and analog inputs. TI recommends to use filters with a narrow passband (within 5%-15% of the desired bandwidth), and minimal insertion loss.
  • SMA cables to connect the inputs.