SBOU297A April   2024  – July 2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Additional Images
    2. 2.2 How to Setup
    3. 2.3 Assembly Instructions
    4. 2.4 Power Requirements
    5. 2.5 Setup
    6. 2.6 Header Information
    7. 2.7 Interfaces
    8. 2.8 Best Practices
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1. 4.1 Trademarks
  10. 5Revision History

2.6 Header Information

The AMP-PDK-EVM has surface mount test points populated on the board. The surface mount test points best connect to a banana jack to clip cable or an oscilloscope probe. There are also black headers in each circuit to allow the interface between the AMP-PDK-EVM and a daughtercard. If connecting a piece of equipment that has BNC connections, then TI recommends to use a BNC-to-clip adapter.