SBOU297A April   2024  – July 2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Additional Images
    2. 2.2 How to Setup
    3. 2.3 Assembly Instructions
    4. 2.4 Power Requirements
    5. 2.5 Setup
    6. 2.6 Header Information
    7. 2.7 Interfaces
    8. 2.8 Best Practices
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1. 4.1 Trademarks
  10. 5Revision History

2.4 Power Requirements

The four preconfigured op amp test circuits are powered by V+ (positive supply), GND (ground reference), and V- (negative supply). The triple power supply connection is required for proper biasing of the preconfigured circuits. The power connection can be accessed either through banana jack connectors or surface mount test points, both are not required.

AMP-PDK-EVM V+, V-, GND Available in Banana Jack Connectors or Surface Mount Test Points Figure 2-8 V+, V-, GND Available in Banana Jack Connectors or Surface Mount Test Points

The pin-to-pin partition has separate power supplies and ground. The pin-to-pin circuit is powered by V+_p2p (positive supply), GND_p2p (ground reference), and V-_p2p (negative supply). A requirement is to access the pin-to-pin power connection through the surface mount test points.

AMP-PDK-EVM V+_p2p, V-_p2p, GND_p2p Available in Surface Mount Connectors Figure 2-9 V+_p2p, V-_p2p, GND_p2p Available in Surface Mount Connectors