SLAU813A September   2019  – October 2020 TPA6304-Q1

 

  1.   Trademarks
  2. 1Required Equipment and Accessories:
  3. 2Hardware Overview
    1. 2.1 TPA6304Q1 Evaluation Module Description
    2. 2.2 TPA6304-Q1 Evaluation Module Functions
  4. 3Software Overview
    1. 3.1 PurePath™ Console 3 (PPC3) Access and Description
    2. 3.2 PurePath™ Console 3 – TPA6304Q1EVM Home Window
    3. 3.3 PurePath™ Console 3 – TPA6304Q1EVM Register Map Window
    4. 3.4 PurePath™ Console 3 – TPA6304Q1EVM Monitor & Control Window
  5. 4TPA6304-Q1 Start Up
    1. 4.1 TPA6304Q1EVM Setup
    2. 4.2 TPA6304-Q1 Settings on Device Monitor & Control Window
      1. 4.2.1 Device State Control Section
      2. 4.2.2 Channel Control Section
      3. 4.2.3 Miscellaneous Control Section
      4. 4.2.4 Fault / Warning Signal Configuration Section
      5. 4.2.5 Faults / Warnings Section
      6. 4.2.6 AC Load Diagnostics Section
      7. 4.2.7 DC Load Diagnostics Section
      8. 4.2.8 Spread Spectrum Control Section
    3. 4.3 TPA6304-Q1 Settings on Register Map Window
    4. 4.4 I2C Monitor Window
  6. 5Board Layout, Schematic and Bill of Materials
    1. 5.1 Board Layout
    2. 5.2 Schematic
    3. 5.3 Bill of Materials
  7.   Revision History

4.2.5 Faults / Warnings Section

The top right buttons on the Faults / Warnings box serve as controlling and monitoring faults. Clip enable route the clip detection bit to the warning pin. This is displayed as a yellow LED on the EVM. Thermal enable route the overtemperature warning bit to the warning pin. This is displayed as the same yellow LED on the EVM. The Clear button clears all the faults and warnings. The Read button manually read the faults and warnings.

GUID-0BD1D281-E3CA-4AA7-8394-172BD73B0CAA-low.pngFigure 4-8 Faults / Warnings Section