SLAU813A September   2019  – October 2020 TPA6304-Q1

 

  1.   Trademarks
  2. 1Required Equipment and Accessories:
  3. 2Hardware Overview
    1. 2.1 TPA6304Q1 Evaluation Module Description
    2. 2.2 TPA6304-Q1 Evaluation Module Functions
  4. 3Software Overview
    1. 3.1 PurePath™ Console 3 (PPC3) Access and Description
    2. 3.2 PurePath™ Console 3 – TPA6304Q1EVM Home Window
    3. 3.3 PurePath™ Console 3 – TPA6304Q1EVM Register Map Window
    4. 3.4 PurePath™ Console 3 – TPA6304Q1EVM Monitor & Control Window
  5. 4TPA6304-Q1 Start Up
    1. 4.1 TPA6304Q1EVM Setup
    2. 4.2 TPA6304-Q1 Settings on Device Monitor & Control Window
      1. 4.2.1 Device State Control Section
      2. 4.2.2 Channel Control Section
      3. 4.2.3 Miscellaneous Control Section
      4. 4.2.4 Fault / Warning Signal Configuration Section
      5. 4.2.5 Faults / Warnings Section
      6. 4.2.6 AC Load Diagnostics Section
      7. 4.2.7 DC Load Diagnostics Section
      8. 4.2.8 Spread Spectrum Control Section
    3. 4.3 TPA6304-Q1 Settings on Register Map Window
    4. 4.4 I2C Monitor Window
  6. 5Board Layout, Schematic and Bill of Materials
    1. 5.1 Board Layout
    2. 5.2 Schematic
    3. 5.3 Bill of Materials
  7.   Revision History

4.2.4 Fault / Warning Signal Configuration Section

This section controls what the Fault and Warning signals report when selected. To get to this section click theGUID-B428C6DC-D45B-4F6C-AE05-3385C7AB3530-low.pngicon on the top right of the Miscellaneous Control Section. This changes the display to show Figure 4-7.

GUID-20200915-CA0I-4GBX-ZV9G-CJTV2P0LS9VX-low.pngFigure 4-7 Fault / Warning Signal Configuration Section

The Warning signal can be set to report when a Clip, Invalid Clock, Overtemperature Shutdown (OTSD), Power Fault, overtemperature warning (OTW), Temperature Gain Foldback (TGFB), or ILimit event is triggered. By default, Warning does not have any event selected.

The Fault signal can be set to report when a Protective Shutdown, Invalid Clock, OTSD, Power Fault, DC fault detection, Overcurrent (OC), or ILimit event is triggered. By default the Fault signal will report a fault only when a DC, OC, or ILimit event is detected.