SLAU949 September   2024

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  6. 2Hardware
    1. 2.1 EVM Setup and Operation
    2. 2.2 Pin Configuration of Opto-emulators
  7. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layout and 3D Diagram
    3. 3.3 Bill of Materials
  8. 4Additional Information
    1. 4.1 Trademarks

1.1 Introduction

The ISOM-EVM supports evaluation of TI's Opto-emulators in a 5-pin DFF, 4-pin DFG, 4-pin DFH, and 4-pin DFS SOIC packages. The EVM can be reconfigured for evaluation for different Opto-emulators, different input signal, or other applications by changing the EVM configuration and component values. The EVM does not have Opto-emulator ICs mounted on the board to allow the user to mount a compatible IC of their own choosing. The user can break apart the board into three separate units to test the PCBs individually. The user's guide also covers the pin configuration of Opto-emulators, EVM schematic, and typical setup.

CAUTION: This evaluation module is made available for isolator parameter performance evaluation only and is not intended for isolation voltage testing. To prevent damage to the EVM, any voltage applied as a supply or digital input/output must be maintained within the recommended operating conditions of the device.