SLLSEH0F July   2013  – August 2014 SN65HVD01

PRODUCTION DATA.  

  1. 1 Features
  2. 2 Applications
  3. 3 Description
  4. 4 Revision History
  5. 5 Pin Configuration and Functions
  6. 6 Specifications
    1. 6.1 Absolute Maximum Ratings
    2. 6.2 Recommended Operating Conditions
    3. 6.3 Thermal Information
    4. 6.4 Dissipation Ratings
    5. 6.5 Electrical Characteristics
    6. 6.6 Switching Characteristics
    7. 6.7 Typical Characteristics
  7. 7 Parameter Measurement Information
  8. 8 Detailed Description
    1. 8.1 Overview
    2. 8.2 Functional Block Diagram
    3. 8.3 Feature Description
    4. 8.4 Device Functional Modes
      1. 8.4.1 Equivalent Input and Output Schematic Diagrams
  9. 9 Applications and Implementation
    1. 9.1 Application Information
    2. 9.2 Typical Application
      1. 9.2.1 Design Requirements
        1. 9.2.1.1 Data Rate and Bus Length
        2. 9.2.1.2 Bus Loading
      2. 9.2.2 Detailed Design Procedure
      3. 9.2.3 Application Performance Curves
  10. 10Power Supply Recommendations
  11. 11Layout
    1. 11.1 Layout Guidelines
    2. 11.2 Layout Example
  12. 12Device and Documentation Support
    1. 12.1 Trademarks
    2. 12.2 Electrostatic Discharge Caution
    3. 12.3 Glossary
  13. 13Mechanical, Packaging, and Orderable Information

7 Parameter Measurement Information

Input generator rate is 100 kbps, 50% duty cycle, rise and fall times less than 6 nsec.

s0301-01_llsEh0.gifFigure 9. Measurement of Driver Differential Output Voltage with Common-Mode Load
s0302-01_llsEh0.gifFigure 10. Measurement of Driver Differential and Common-Mode Output with RS-485 Load
pmi_dr_sw_llsEh0.gifFigure 11. Measurement of Driver Differential Output Rise and Fall Times and Propagation Delays
s0304-01_llsEh0.gif
D at VL to test non-inverting output, D at 0 V to test inverting output.
Figure 12. Measurement of Driver Enable and Disable Times with Active High Output and Pull-Down Load
s0305-01_llsEh0.gif
D at 0V to test non-inverting output, D at VL to test inverting output.
Figure 13. Measurement of Driver Enable and Disable Times with Active Low Output and Pull-Up Load
s0306-01_llsEh0.gifFigure 14. Measurement of Receiver Output Rise and Fall Times and Propagation Delays
s0307-01_llsEh0.gifFigure 15. Measurement of Receiver Enable/Disable Times with Driver Enabled
s0308-01_llsEh0.gifFigure 16. Measurement of Receiver Enable Times with Driver Disabled