SLUUC48A February   2020  – February 2022 TPS546B24A

1.   Trademarks
2. 1 Description
   1. 1.1 Before You Begin
   2. 1.2 Typical Applications
   3. 1.3 Features
3. 2 Electrical Performance Specifications
4. 3 Schematic
5. 4 Test Setup
   1. 4.1 Test and Configuration Software
      1. 4.1.1 Description
      2. 4.1.2 Features
   2. 4.2 Test Equipment
      1. 4.2.1 Voltage Source
      2. 4.2.2 Multimeters
      3. 4.2.3 Output Load
      4. 4.2.4 Oscilloscope
      5. 4.2.5 Fan
      6. 4.2.6 USB-to-GPIO Interface Adapter
      7. 4.2.7 Recommended Wire Gauge
   3. 4.3 Tip and Barrel Measurement
   4. 4.4 List of Test Points, Jumpers, and Connectors
   5. 4.5 Evaluating Single Phase Operation
   6. 4.6 Evaluating Split Rail Input
   7. 4.7 Configuring EVM to Overdrive VDD5
6. 5 EVM Configuration Using the Fusion GUI
   1. 5.1 Configuration Procedure
7. 6 Test Procedure
   1. 6.1 Line and Load Regulation and Efficiency Measurement Procedure
   2. 6.2 Efficiency Measurement Test Points
   3. 6.3 Control Loop Gain and Phase Measurement Procedure
8. 7 Performance Data and Typical Characteristic Curves
   1. 7.1  Efficiency
   2. 7.2  Load and Line Regulation (Measured Between TP22 and TP25)
   3. 7.3  Transient Response
   4. 7.4  Control Loop Bode Plot
   5. 7.5  Output Ripple
   6. 7.6  Power MOSFET Drain-Source Voltage
   7. 7.7  Control On
   8. 7.8  Control Off
   9. 7.9  Control On with Pre-Biased Output
   10. 7.10 Current Sharing Between Two Phases
   11. 7.11 Thermal Image
9. 8 EVM Assembly Drawing and PCB Layout
10. 9 Bill of Materials
11. 10Using the Fusion GUI
    1. 10.1  Opening the Fusion GUI
    2. 10.2  General Settings
    3. 10.3  Changing ON_OFF_CONFIG
    4. 10.4  Pop-up for Some Commands While Conversion is Enabled
    5. 10.5  SMBALERT# Mask
    6. 10.6  Device Info
    7. 10.7  Phase Commands
    8. 10.8  All Config
    9. 10.9  Pin Strapping
    10. 10.10 Monitor
    11. 10.11 Status
12. 11Revision History