SLUUCF3A December   2020  – October 2021 BQ25672

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 EVM Features
    2. 1.2 I/O Descriptions
    3. 1.3 Recommended Operating Conditions
  3. 2Test Setup and Results
    1. 2.1 Equipment
    2. 2.2 Equipment Setup
    3. 2.3 Software Setup
      1. 2.3.1 BQSTUDIO using EV2400
      2. 2.3.2 TI Charger GUI for USB2ANY
    4. 2.4 Test Procedure
      1. 2.4.1 Initial Settings
      2. 2.4.2 Communication Verification
      3. 2.4.3 Charge Mode Verification
      4. 2.4.4 OTG Mode Verification
  4. 3PCB Layout Guidelines
  5. 4Board Layout, Schematic and Bill of Materials
    1. 4.1 BMS034E1 Board Layout
    2. 4.2 BQ25672EVM (BMS034E1-004) Schematic
    3. 4.3 Bill of Materials
  6. 5Revision History

4.1 BMS034E1 Board Layout

Figure 4-1 through Figure 4-4 illustrate the schematic for the BQ25672EVM

GUID-7791DA5E-0455-4CEF-BDC5-47AC0CF01BE8-low.gif Figure 4-1 BMS034E2/A Top Layer
GUID-E3AC29E5-0BCB-4CA5-8FB0-6C0E758CB3C5-low.gif Figure 4-2 BMS034E2/A Signal Layer 1
GUID-B3432F70-BFB0-4E9E-BCD3-D435BC0952DE-low.gif Figure 4-3 BMS034E2/A Signal Layer 2
GUID-1312623A-295A-47BC-963D-E9AA9FFB6C8B-low.gif Figure 4-4 BMS034E2/A Bottom Layer