SLVU728A May   2012  – December 2021 TPS53318 , TPS53319

 

  1. 1 Introduction
    1. 1.1 Typical Applications
    2. 1.2 Features
  2. 2 Electrical Performance Specifications
  3. 3 Schematic
  4. 4 Test Setup
    1. 4.1 Test Equipment
    2. 4.2 Recommended Test Setup
  5. 5 Configurations
    1. 5.1 Switching Frequency Selection
    2. 5.2 Soft Start Selection
    3. 5.3 Mode Selection
    4. 5.4 Enable Selection
  6. 6 Test Procedure
    1. 6.1 Line/Load Regulation and Efficiency Measurement Procedure
    2. 6.2 Control Loop Gain and Phase Measurement Procedure
    3. 6.3 List of Test Points
    4. 6.4 Equipment Shutdown
  7. 7 Performance Data and Typical Characteristic Curves
    1. 7.1  Efficiency
    2. 7.2  Load Regulation
    3. 7.3  Line Regulation
    4. 7.4  Enable Turn-On/ Turn-Off
    5. 7.5  Output Ripple
    6. 7.6  Switching Node
    7. 7.7  Output Transient with Auto-skip Mode
    8. 7.8  Output Transient with FCCM mode
    9. 7.9  Output 0.75-V Pre-bias Turn-On
    10. 7.10 Output Overcurrent and Short Circuit Protection
    11. 7.11 Bode plot
    12. 7.12 Thermal Image
  8. 8 EVM Assembly Drawing and PCB Layout
  9. 9 Bill of Materials
  10. 10Revision History

5.3 Mode Selection

The MODE can be set by J5.
Default setting: Auto Skip

Table 5-3 MODE Selection
Jumper set toMODE Selection
Top(1-2 pin shorted)Auto Skip
Bottom(3-4 pin shorted)Forced CCM