SLVU957A September   2019  – November 2021 BQ76922

 

  1.   Trademarks
  2. 1Features
    1. 1.1 Kit Contents
    2. 1.2 Ordering Information
    3. 1.3 BQ76922EVM Circuit Module Performance Specification Summary
    4. 1.4 Required Equipment
  3. 2BQ76922EVM Quick Start Guide
    1. 2.1 Before You Begin
    2. 2.2 Quick Start
  4. 3Interface Adapter
  5. 4Battery Management Studio Software
    1. 4.1 System Requirements
    2. 4.2 Installing BQStudio
    3. 4.3 BQ76922 bqz File Installation
    4. 4.4 BQStudio Operation and Registers View
    5. 4.5 Commands
    6. 4.6 Data Memory
      1. 4.6.1 Entering, Saving, and Loading Configuration
      2. 4.6.2 OTP Programming
    7. 4.7 Calibration
    8. 4.8 Command Sequences
  6. 5BQ76922EVM Circuit Module Use
    1. 5.1 Cell Simulator
    2. 5.2 Evaluating with Load Current
    3. 5.3 Evaluating Charge and Discharge Currents
    4. 5.4 Evaluating with Simulated Current
    5. 5.5 Reducing the Cell Count
    6. 5.6 Connecting Cells
    7. 5.7 Connecting to a Host
    8. 5.8 Hardware Configuration
      1. 5.8.1 Configuration Jumpers
      2. 5.8.2 Unused Components
    9. 5.9 Configuration Register Programming
  7. 6BQ76922EVM Circuit Module Physical Construction
    1. 6.1 Board Layout
    2. 6.2 Bill of Materials
    3. 6.3 REACH Compliance
    4. 6.4 Schematic
  8. 7Related Documents from Texas Instruments
  9. 8Revision History

BQ76922 bqz File Installation

The BQStudio software uses a bqz file to configure the displays for the BQ76922 device or family devices. This is normally provided in the BQStudio installation. If provided separately, copy the .bqz file to the config directory in the installation, typically C:\ti\BatteryManagementStudio\config.